Crestron clti-1mc4 clxi-1mc4 User Manual

Crestron CLTI- & CLXI-1MC4   

Terminal Block & Module 

JUMPER INSTALLED

RED

BROWN

YELLOW

RED

YELLOW

RED

YELLOW

RED

YELLOW

JUMPER ON BLUE

SECTION REMAINS

INSTALLED.

BLUE

 

CAUTION:  Module contains electrostatic sensitive 
devices (ESDs); unit must be handled from metal 
chassis – do not touch PC board or components. 

NOTE:  Modules are to be installed after enclosure 
has been completely wired. Refer to the terminal 
block installation procedure on page 2 for details.  

1.  Use the four supplied self-tapping pan Phillips 

screws (8B x ¼-inch (6 mm) length)  to secure 
the module to the enclosure.  

2.  As shown in the wiring diagrams (next column), 

connect the wires from the module to the 
terminal block. Each wire exits the module 
directly in line with, and is the same color as, the 
terminal to which it should be connected. Wires 
are pre-stripped to 12 mm. Tighten to 1 Nm. Do 
not over tighten.  

3.  If the module is being installed above another 

module within the enclosure, attach the supplied 
module interconnect cable between the two 
modules. The illustration below depicts the area 
within a double-wide enclosure where the 
corners of four modules meet.  

NOTE:  One wire on the module interconnect cable 
may be a different color from the rest. The color has 
no bearing on its orientation during installation.  

JUMPER INSTALLED

RED

BROWN

BLUE

YELLOW

RED

YELLOW

RED

YELLOW

RED

YELLOW

JUMPER ON BLUE

SECTION REMAINS

INSTALLED.

 

              

MODULE

INTERCONNECT

CABLE ATTACHED

CONNECTION

NOT

MADE

 

4.  Turn on the circuit breaker and verify that the 

green PWR LED on the module lights and the 
breaker does not trip.  

•  3