Crestron cnxrmak User Manual

The CNXRMAK is a 2-space rack mount kit that used to install up to three Crestron



 C2N-HBLOCK 

Cresnet



 distribution blocks or three CNPWS-75 Cresnet power supplies (or any combination thereof) 

into a 19-inch EIA equipment rack. The kit consists of the black finished 2U mounting plate (part # 
2004738, shown below) and twelve (12) 6-32, 3/8” pan head Phillips screws (part # 2007225). The 
only tools required for installation are a #2 Phillips 1/4-inch hex bit and an inch-pound torque driver.  

3.50 in

(8.89 cm)

19.00 in

(48.26 cm)

CNXRMAK

CNXRMAK

ZA11325

C000000

THICKNESS = 0.12 in (0.30 cm)

 

As of the date of manufacture, this unit has been tested and found to comply with specifications for CE 
marking. 

WARNING:  To prevent bodily injury when mounting or servicing this unit in a rack, you must take 
special precautions to ensure that the system remains stable. The following guidelines are provided to 
ensure your safety: 

 

The unit should be mounted at the bottom of the rack if it is the only unit in the rack. 

 

When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the 
heaviest component at the bottom of the rack. 

 

If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing 
the unit in the rack. 

•  1