Clifford 590.4x User Manual

46

© 2011 Directed Electronics. All rights reserved.

Valet Mode

Valet mode can be entered and exited by performing the Remote Valet 
command or manually using the vehicle key and the control button. 
When entered, the alarm functions are defeated while the conve-
nience features still operate normally. 
Arm and Disarm commands lock and unlock the doors while the 

 and 

 animations and beeps play 

to confirm.

Use the following steps to manually enter and exit Valet Mode:
1.  Turn the ignition switch On and then Off
2. Immediately 

press and release the control button once

3.  The control center LED turns On when entering and Off when 

exiting.

Power Save

To reduce power consumption the control center status LED modifies 
its output if the vehicle is parked for an extended period. If Armed the 
flashing is reduced after 24 hours. When Valet mode is On, the LED 
turns off after 1 hour and resets each time the ignition is turned off.

Rapid Resume

If power is ever disconnected by a mechanic or thief, the system will 
resume the state it was in at the time of disconnection, when power 
is reconnected.

Automatic Remote Updates

The system sends a silent message to all remote controls after any 
major action has occurred. When the remote receives this message it 
updates the status screen icons. This way all users are able to quickly 
review the system status just by accessing the status screen.