Brother HL-2400CEN User Manual
CHAPTER 2 SETTING UP THE PRINTER
2–17
!
Caution
Always wait at least 5 seconds after turning off the power before turning
it on again.
Do not turn the power off while the printer is printing as this may cause a
paper jam and adversely affect the printer.
it on again.
Do not turn the power off while the printer is printing as this may cause a
paper jam and adversely affect the printer.
The printer performs self-diagnosis at start-up to check its hardware and
software. If the printer should find any problems, the display will change
to show the corresponding error message. See “
The display shows several messages quickly at start-up. If the printer
detects no errors, the printer initializes. This will take several minutes
during which time the LCD will display the following message :
detects no errors, the printer initializes. This will take several minutes
during which time the LCD will display the following message :
LJ WAIT 001P T1
AUTO
K C M Y
Once the printer has finished initializing, it automatically goes on-line
and the message changes to show the current printer status and
settings as shown below:
and the message changes to show the current printer status and
settings as shown below:
LJ READY 001P T1
AUTO
K C M Y
AUTO:
The auto emulation selection mode is set.
LJ : The auto emulation selection is set and currently the HP
PCL5C emulation is selected.
PCL5C emulation is selected.
READY :
The printer is ready to print.
001 :The number of copies to print is set to 1.
P :
Portrait print is selected.
T1 : Paper is fed from Tray1.
I : Toner cartridges are full. When the toner cartridges
become nearly empty, the
become nearly empty, the
I indication blinks. The I
indication disappears when a color toner is empty.