Intermatic 158wf12662ref User Manual

WF403

GENERAL INSTRUCTIONS FOR WATERFALL USE

1. Unpack the product, wipe off dust with a damp cloth. Take out all

accessories: pump and light with adapter.

2. Familiarize yourself with the pump. Turn valve on pump counter clockwise

placing the handle in a horizontal position for maximum water flow. Turn the

valve on the pump in a vertical position for minimum water flow.

CAUTION: This pump has been evaluated for use with water only.

NOTE

: It is recommended the pump be set at its highest flow during assembly

and later adjusted to a lower setting if desired. Be sure to unplug pump before

adjusting flow setting.

WARNING

: RISK OF ELECTRICAL SHOCK

• Do not connect to any voltage other than that shown on the pump.

• This pump is supplied with a grounding conductor and grounding-type attach-

ment plug. To reduce the risk of electric shock, be certain that it is connected

only to a properly grounded, grounding-type receptacle.

• The national electric code requires that a ground fault circuit interrupter (GFCI)

be used in the branch circuit supplying fountain pumps and other pond equip-

ment. See your electrical supplies dealer for this device.

• If the supply cable is damaged it can not be replaced and the pump unit should

be discarded.

WARNING

: RISK OF FIRE

• Do not use with water above 30˚C.

• Do not pump flammable liquids.

3. Attach the pump to the connector tube on the fountain and place the pump inside

the fountain. Place the light in socket at base of fountain. Run the cord through

the hole into the base of the fountain out the back, lay with power cord from

pump. Connect cord from light to A/C adapter and tighten.

NOTE: Do not let pump run when NOT submerged in water. Doing so may damage the pump. Always submerge

the pump in water first, and then plug in the unit.
4. Fill base with tap water to approximately 1/2" above pump. Distilled water is recommended in order to minimize

mineral deposits.

NOTICE: Do not place outdoors in weather conditions below 32˚F, may cause water to freeze.
5. Plug cord into 120V household outlet. Turn pump on to verify flow making sure it is not too high and everything is

operating correctly. Arrange river rocks on top of plate.

NOTE: Ensure that the electrical cord loop below the electrical outlet.” This will prevent water from running down

the cord into the electrical outlet.

WARNING

•

Do not connect with wet hands.

•

Lens and shade get hot.

IMPORTANT SAFETY INSTRUCTIONS

LIGHTED LAMP IS HOT

TO REDUCE THE RISK OF FIRE OR INJURY TO PERSONS:

• Turn off/unplug and allow to cool before replacing lamp.

• Lamp gets HOT quickly! Contact only switch/plug when turning on.

• Keep lamp away from materials that may burn.

• Do not touch the lamp at any time. Use a soft cloth. Oil from skin may damage lamp.

• Do not operate the luminaire fitting with a missing or damaged shield.

• Do not touch hot lens, guard, shade, or enclosure.