INSTEON 2412N User Manual

19

®

Rev. 6/19/2012 11:45 AM

Electrical
Supply Voltage

120V +/- 10%, 60Hz, single phase

Surge Protection

MOV rated for 150V

Power Plug

3-pin grounded

Pass-Through Outlet

Uncontrolled 3-pin (grounded), 120V, 15A

Power Consumption

2.11W

Certification

Safety-tested for use in USA and Canada (ETL #3017581)

Default Application
Maximum Number of Scenes/De-

vices

240

Number of Rooms

15

Scene/Device Commands Sup-

ported

On

Off

Dim

Brighten

Timer Events Supported

1 On and 1 Off timer per day per scene/device

Maximum Number of Timer Events

480 per day (240 On, 240 Off)

Timer Day of the Week Condition

Supported

Browsers Supported

All browsers supported for HTML-only interface;

JavaScript/AJAX enabled browsers for ideal interface use

Linux browsers not currently supported

This product has been thoroughly tested by ITS ETL SEMKO, a nationally recognized independent third-party testing laboratory. The North American

ETL Listed mark signifies that the device has been tested to and has met the requirements of a widely recognized consensus of U.S. and Canadian

device safety standards, that the manufacturing site has been audited, and that the manufacturer has agreed to a program of quarterly factory follow-up 

inspections to verify continued conformance. 

This device complies with FCC Rules Part 15 and Industry Canada RSS-210 (Rev. 7 or 8). Operation is subject to the following two conditions:

 

(1) This device may not cause harmful interference, and 

 

(2) This device must accept any interference, including interference that may cause undesired operation of the device.

Le present appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorise aux deux 

conditions suivantes: 

 

(1) l’appareil ne doit pas produire de brouillage, et 

 

(2) l’utilisateur de l’appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d’en compromettre le 

                     fonctionnement.

The digital circuitry of this device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. 

These limits are designed to provide reasonable protection against harmful interference in residential installations. This equipment generates, uses, and 

can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio and televi-

sion reception. However, there is no guarantee that interference will not occur in a particular installation. If this device does cause such interference, 

which can be verified by turning the device off and on, the user is encouraged to eliminate the interference by one or more of the following measures:

 

- Re-orient or relocate the receiving antenna of the device experiencing the interference

 

- Increase the distance between this device and the receiver

 

- Connect the device to an AC outlet on a circuit different from the one that supplies power to the receiver

- Consult the dealer or an experienced radio/TV technician

WARNING: Changes or modifications to this device not expressly approved by the party responsible for compliance could void the user’s authority to

operate the equipment. 

CAUTION: To reduce the risk of overheating and possible damage to other equipment, do not install this device to control a receptacle, a motor-operated 

appliance, a fluorescent lighting fixture, or a transformer-supplied appliance.

Gradateurs commandant une lampe a filament de tungstene – afin de reduire le risqué de surchauffe et la possibilite d’endommagement a d’autres

materiels, ne pas installer pour commander une prise, un appareil a moteur, une lampe fluorescente ou un appareil alimente par un transformateur.