Lantronix 900-422 User Manual
Chapter 3: Installation and Hardware
XPress DR+ User Guide
19
Figure 3-1. Typical Configuration
1. Connect a serial device to your XPress DR+. (See Serial Interface on page 20 for
cable and connector specifications.)
2. Connect an Ethernet cable to the Ethernet port. (See
Ethernet Interface
on page 23.)
3. Supply power to your XPress DR+ using a 9-30 VDC or 9-24 VAC (2.3W maximum)
source. (See
Power Requirements
on page 24.)
4. Supply power to the serial device.
Note:
Connecting a device to an active Ethernet network can disrupt
communications on the network. Make sure the device is configured for your
application before connecting it to an active network
application before connecting it to an active network
XPress DR+ Front Panel
The following figure illustrates the screw block connector pinouts and other components
of the XPress DR+.
of the XPress DR+.
Note:
For a description of the XPress DR+W front panel, see
Chapter 4: XPress
DR+W
.