Line 6 AXSys 212 User Manual

Appendices

AxSys 212 UserÕs Manual

39

If you are experience problems while operating the AxSys 212, please use
the following table to locate possible causes and solutions before
contacting Line 6 customer service for assistance.

Symptom

Cause

Solution

The display does not light
when the POWER switch
is turned on.

No power.

Check that the power cable is
plugged in properly.

No sound.

Speakers are not
connected to amp.

Connect the speaker cables to
the rear panel LEFT
SPEAKER

 and RIGHT

 jacks

Bad cable.

Check your guitar cables;
replace if necessary.

Volume is turned down.

Raise the MASTER knob.

Control Knobs wonÕt
change parameter settings.

Compare mode is turned
on (

C appears in display)

Press COMPARE to exit
Compare mode.

Disconnect the AC cord, then use a damp cloth to clean the ampÕs metal
and plastic surfaces. For heavy dirt, use a non-abrasive household cleaner
such as Formula 409 or Fantastik. DO NOT SPRAY THE CLEANER
DIRECTLY ONTO THE FRONT OF THE UNIT AS IT MAY DAMAGE
THE LUBRICANTS USED IN THE SWITCHES AND CONTROLS! Spray
onto a cloth, then use the cloth to clean the unit.

Here are some tips for preventive maintenance.

¥ Periodically check the AC cord for signs of fraying or damage.

¥ Place a dust cover over the AxSys 212 when it is not in use.

We believe that the AxSys 212 is one of the most reliable amps that can be
made using current technology, and should provide years of trouble-free
use. However, should problems occur, DO NOT attempt to service the
amp yourself. The full AC line voltage, as well as high voltage/high
current DC voltages, are present at several points within the chassis.
Service on this product should be performed only by qualified technicians.
THERE ARE NO USER-SERVICEABLE PARTS INSIDE.