Konica Minolta micropress release 6 User Manual
46
Door Open
Main door is open.
Jam Resolution
Press button for jam information.
Update
Updates information on all tabs.
Density Adjust
Current density setting of the PrintStation.
Engine Type
Displays model of the currently selected DesignJet.
Ink Type
Type of ink currently installed, if known.
Take Up Reel
Indicates if a take up reel is installed.
Firmware Rev.
Revision level of the firmware in the DesignJet.
Ink Levels
Ink levels in the cartridges (within a 20% error margin).
Paper Roll
• Initial Paper Roll Length (feet) – When loading roll media, enter the length of the roll of
media here so usage can be tracked and SafePrint will function properly.
• Current Paper Roll Length (feet) – Used in conjunction with the initial length. The amount
of media remaining on the roll.
• Paper Width – Detected by the printer.
• Paper Type – Type of paper currently loaded (taken from the DesignJet CP front panel).
• Paper Type – Type of paper currently loaded (taken from the DesignJet CP front panel).
Sheet Feed (1000 only)
• Paper Width (inches)
• Paper Length (inches)
• Paper Type
• Paper Length (inches)
• Paper Type
Separators From
Select the correct paper source to pull separator paper from.
Duplex Adjust
Aligns the images on both surfaces of a duplexed job so they are placed in the same
relative location on the page. The adjustment is from 1 to 15 (10 being the default) with
each increment moving the image approximately .5mm. The image on the back surface
remains stationary and the adjustment is done to the front surface image. A larger number
moves the image closer to the leading edge of the paper.
relative location on the page. The adjustment is from 1 to 15 (10 being the default) with
each increment moving the image approximately .5mm. The image on the back surface
remains stationary and the adjustment is done to the front surface image. A larger number
moves the image closer to the leading edge of the paper.
Sleep after x minutes
Time period from the last printed page until the PrintStation goes to "sleep" (low power
mode). Printer will automatically wake when a new job arrives.
mode). Printer will automatically wake when a new job arrives.
Media Handling
• 1
st
, 2
nd
and 3
rd
Drawer display the quantity and size of the paper in the tray
• LCC (Large Capacity Cassette) displays the quantity and size of the paper in the cassette
or Not Present if the LCC is not available
• Finisher displays Present or Not present depending on availability of the Finisher. Punch-
ing displays No Punching, 2 hole or 3 hole.
• Manual Tray displays paper size in tray. Select Transparency or Thick paper from drop-
down list.
Engine Settings
• Separators from –sets correct paper source to pull separator paper from.
• Empty Tray Switch Skips – From the drop down-list, select the paper source to skip if one
• Empty Tray Switch Skips – From the drop down-list, select the paper source to skip if one
paper tray runs out of paper during printing.
• Density – Current density setting of the PrintStation. Use this setting to select density
level.
• Error on Toner Low – Selecting this option causes engine to stop printing when the toner is
empty rather than displaying a warning and continuing to print.
• Finisher Mode – 4 modes:
– Mailbox
– Collator
– Job Separation
– Stacking
– Collator
– Job Separation
– Stacking
Total Page Count
Total number of one-sided Letter and A4 pages printed.
IP Address
Displays currently assigned IP Address (assigned in PrintStation Configuration).
Model
Type of PrintStation connected to the MicroPress Server.
Capabilities
Displays additional functionality for the connected device.
Status
Indicates online status of the PrintStation.
Field/Control
Description