Konica Minolta micropress release 6 User Manual
52
Miscellaneous
Printer Status Miscellaneous dialog displays miscellaneous Printer Status information that
identifies gloss levels, number of pages printed, current Printer Status, density settings and a
printer sleep option.
To display Printer Status Unit Errors:
1 Click PrintStation button.
2 Click Miscellaneous tab.
2 Click Miscellaneous tab.
The table below describes conditions in the Printer Status Miscellaneous dialog.
Feed Tray
Trays page displays information about the media inputs for the PrintStation.
To display Feed Tray Status information:
1 Click PrintStation button.
2 Click Trays tab.
2 Click Trays tab.
Note:
Place the mouse cursor over a Tray Level status bar to see an estimate of media remaining in the
DC Controller Failures
DC Controller Failures:
• Memory
• 5V, 24V
• Thermal/Humidity Sensor
• Density Sensor
• Communication
• IC Chips
• 5V, 24V
• Thermal/Humidity Sensor
• Density Sensor
• Communication
• IC Chips
Field/Control
Description
Field/Control
Description
Gloss Level
Current gloss level for this PrintStation.
Note: Access the Gloss Level option in the Job Settings, Page Settings, or Virtual Engine
Defaults dialog.
Note: Access the Gloss Level option in the Job Settings, Page Settings, or Virtual Engine
Defaults dialog.
Sleep After Last Page
Time period from the last printed page until the engine goes to “sleep” (low power mode).
Printer automatically wakes when a new job arrives.
Printer automatically wakes when a new job arrives.
Total Pages Printed
Total number of pages printed on this PrintStation (cannot be reset).
Page Counter:
Number of pages printed since the last time the “Reset” button was pushed.
Engine Firmware Revision
Version of the firmware in the PrintStation
Kernel Driver Version
Version of the drivers on the PrintStation.
Adapter Version
Version of the firmware on the PrintAdapter board.
Current Status
Following status information:
• Fuser and Main Motor Sleeping
• Ready Line
• Quality Print Mode
• Drum Past Life Expectancy
• Ready Line
• Quality Print Mode
• Drum Past Life Expectancy
Current Density Settings
Current Cyan, Magenta, Yellow, and Black toner density settings. The Current Density
Settings should display a value of zero (0). If not, you must manually reset them on the rear
panel of the PrintStation 312.
Settings should display a value of zero (0). If not, you must manually reset them on the rear
panel of the PrintStation 312.
Gamma Calibration
Click the Gamma Calibration button to load a different .gam file or to save the current file
with another name.
with another name.