Konica Minolta micropress release 6 User Manual
55
Covers
The Covers page displays the name and status for covers, or doors, on the PrintStation. Sta-
tus will indicate if the cover, or door, is properly positioned in order to function correctly.
Tab Setup
To display the Tab Setup dialog:
1. On the active VE click the PrintStation button.
2. Click the Tab Setup tab.
1. On the active VE click the PrintStation button.
2. Click the Tab Setup tab.
The table below describes the Tab Setup dialog.
Engine Density
A slight color change in one PrintStation may be needed to lock in accurate balance for all
PrintStations. For this reason, modify the Engine Density and/or Engine Exposure Adjust to
fine-tune calibrations. From these dialogs, you can quickly change a PrintStations™ color
and apply it to all current and future jobs. Developer bias voltage is adjusted on the Engine
Field/Control
Description
Tab Set
• Banked – Each tab position is offset. Banks should always be full sets and start at
position 1.
• Not Banked – Each tab is in the same position
See the following graphic example of Banked and Not Banked tab sets.
Bank Size
Number of tab positions in a set. Graphic following shows a Bank Size of 3.
Eject Tray
When resetting the tabs, the specified tray is used to send the ejected tab page
Source Tray Information
• Tab Position – Position of the tab on the tab page. If using a banked tab set, the only
option will be All. With tab sets that are not banked, each position in the set will be listed.
The result is placed in the lower window.
Note: for the 0110i, MP_TAB01 will be the media type for All in a Banked set. With a Not
Banked set, MP_TAB01, MP_TAB02, etc. would be listed with each corresponding to an
input tray. The MP_TAB0x (x = the number of an input tray) media names must be set up
through the 0110i Printer Monitor in the media catalog.
The result is placed in the lower window.
Note: for the 0110i, MP_TAB01 will be the media type for All in a Banked set. With a Not
Banked set, MP_TAB01, MP_TAB02, etc. would be listed with each corresponding to an
input tray. The MP_TAB0x (x = the number of an input tray) media names must be set up
through the 0110i Printer Monitor in the media catalog.
• Feed Tray – Tray from which Tabs will be pulled.
• Add – If using a Not Banked tab set, this box will list the tab positions based on the Bank
• Add – If using a Not Banked tab set, this box will list the tab positions based on the Bank
Size chosen. Make a selection from Position and Feed Tray, then click Add.
• Reset – Click to erase all selections.
• Remove – Click on the selection to be removed and then click the Remove button.
• Remove – Click on the selection to be removed and then click the Remove button.
Banked Tabs
Not Banked