ZyXEL Communications NXC8160 User Manual
Chapter 5 Wireless LAN
NXC-8160 User’s Guide
53
5.4.1 Rename SSIDs
Click the Rename SSIDs link in the WLAN Configuration screen to change an existing
SSID.
SSID.
1 Mbps ~ 54
Mbps
This is the data rate at which the NXC-8160 can transmit.
Select Adapt to allow the NXC-8160 to switch between and send traffic to wireless
Select Adapt to allow the NXC-8160 to switch between and send traffic to wireless
clients at the specified rates after you select Enable Rate Adaption. If you select
Disabled, the Adapt check box is grayed out and the rate will not be available for
rate adaption even if you have selected it.
Select Basic when your wireless clients can transmit at the specified rate. This
Select Basic when your wireless clients can transmit at the specified rate. This
allows only the wireless devices that support this data rate or higher to connect to
the wireless network. It’s recommended that you set the rate supported by all
wireless devices in your wireless network as the basic rate. Basic is not available
for the extended data rates.
Select Optional to set this rate as an optional choice. The wireless devices that
Select Optional to set this rate as an optional choice. The wireless devices that
support it can choose to communicate with the network at this rate.
Select Disabled to not allow the wireless devices to communicate with the network
Select Disabled to not allow the wireless devices to communicate with the network
at this rate.
You can select Adapt and Basic or Optional at the same time.
You can select Adapt and Basic or Optional at the same time.
Setup SSIDs
The SSID (Service Set IDentifier) identifies the service set with which a wireless
client is associated. Wireless clients associating with the access point (AP) must
have the same SSID.
When a wireless client scans for an AP to associate with, this is the name that is
When a wireless client scans for an AP to associate with, this is the name that is
broadcast and seen in the wireless client utility.
Assigned SSIDs
This text box shows the SSID(s) which is assigned to this radio. You can create and
assign up to 16 SSIDs to a radio.
Select an SSID and click Remove from Channel to delete the SSID from this radio
Select an SSID and click Remove from Channel to delete the SSID from this radio
after you click Save.
Note: You cannot delete all SSIDs from a radio.
Unassigned
SSIDs
This text box shows the SSID(s) which is created on the NXC-8160 but not
assigned to this radio. Select an SSID and click Add to Channel to assign it to this
radio after you click Save.
Note: An SSID cannot be assigned to both radios. If you assign the
radio an SSID that is already assigned to the other radio, the
SSID will be taken out from the other radio.
SSID will be taken out from the other radio.
New SSID
Enter a new SSID and select Create and Assign to add this new SSID to this radio
after you click Save.
Rename SSIDs
Click the Rename SSIDs link to open a screen where you can change the SSID(s)
for more information.
All SSIDs
This text box shows all SSIDs available on the NXC-8160. Select an SSID and click
Delete Permanently to remove it from the NXC-8160.
Edit SSID &
Security Setting
Click the link to go to the SSID & Security screen where you can configure the
wireless and wireless security settings for the specified SSID. See
for more information.
Save
Click Save to save your changes back to the NXC-8160.
Reset
Click Reset to begin configuring this screen afresh.
Table 11 WLAN (continued)
LABEL
DESCRIPTION