Xerox 4213 User Manual
1.
Interfaces
This chapter describes the interfaces supported by the 4213 Laser
Printer, the Centronics and Dataproducts parallel, and the serial
asynchronous.
Printer, the Centronics and Dataproducts parallel, and the serial
asynchronous.
Parallel interface
The 4213 Laser Printer supports two parallel interfaces:
Centronics and Dataproducts. Each is described on the following
pages.
Centronics and Dataproducts. Each is described on the following
pages.
The parallel interface cable
You must supply the interface cable to connect the 4213 to your
host. The cable must meet the following specification in order
to comply with FCC and VDE regulations.
host. The cable must meet the following specification in order
to comply with FCC and VDE regulations.
Table 1-1.
interface cable specifications
Type:
Twisted pairs, overall foil or braid
shield
shield
No. of conductors:
15 pairs
Wire size:
22 AWG stranded
Cable length:
Maximum length: Centronics or
Dataproducts—10 feet (3.05metres)
Dataproducts—10 feet (3.05metres)
Shield connection:
To the connector conductive case
at the 4213; to the frame ground
at the data source
at the 4213; to the frame ground
at the data source
Note
When connecting or disconnecting the parallel interface cable,
make sure the printer is off line.
make sure the printer is off line.
XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE
1-1