ICOM f70t User Manual

15

3

BASIC OPERATION

D TX code number edit

(PMR or BIIS PMR operation only)

If the transceiver has [TX Code CH Select] or [TX Code
Enter] assigned to it, TX code contents can be edited within
the allowable digits.

USING [TX CODE CH SELECT] KEY:
q Push [TX Code CH Select] to enter the TX code channel

selection mode.

• Select the desired channel before entering the TX code channel

selection mode if necessary.

w Push and hold [TX Code CH Select] for 1 sec. to enter the

TX code edit mode.

e Push [TX Code CH Select] to select the desired digit to be

edited.

• The digit to be edited blinks.

r Push [CH Up], [CH Down] or 10-keypad* to set the desired

digit.

t Push [TX Code CH Select] to set the digit. The digit to the

right will blink automatically.

• When the 10-keypad* is used for setting, the digit to the right will

blink automatically without pushing [TX Code CH Select].

y Repeat r and t to input all allowable digits.
u Push [Call] or [PTT] to transmit the edited TX code.

*IC-F70DT/T or IC-F80DT/T only

USING [TX CODE ENTER] KEY:
q Select the desired TX code channel via [TX Code CH

Select]+[CH Up] or [CH Down], [TX Code CH Up] or [TX
Code CH Down].

w Push [TX Code Enter] to enter the TX code edit mode.
e Push [TX Code Enter] to select the desired digit to be edit-

ed.

• The digit to be edited blinks.

r Push [CH Up], [CH Down] or 10-keypad* to set the desired

digit.

t Push [TX Code Enter] to set the digit. The digit to the right

will blink automatically.

• When the 10-keypad* is used for setting, the digit to the right will

blink automatically without pushing [TX Code CH Enter].

y Repeat r and t to input all allowable digits.
u Push [Call] or [PTT] to transmit the edited TX code.

*IC-F70DT/T or IC-F80DT/T only

IC-F70_F80-1.qxd  05.1.18 4:26 PM  Page 15 (1,1)