Terratec sine pa User Manual
Function
The SINE PA 200 studio power amplifier is designed for installation in 19" racks. Please
ensure that it gets adequate ventilation.
ensure that it gets adequate ventilation.
Use the included power cable to connect the PA 200 to an AC power source. Connect
both inputs to the outputs (balanced XLR or unbalanced jack) of your mixer and the
outputs to your speakers (4-8 ohm). Turn both VOLUME controls completely down.
both inputs to the outputs (balanced XLR or unbalanced jack) of your mixer and the
outputs to your speakers (4-8 ohm). Turn both VOLUME controls completely down.
Both LEDs will light up when the power is switched on. The "Protect" LED will go out after
1 to 2 seconds.
1 to 2 seconds.
The power-up delay needs around 10 seconds to become active after turning the
amplifier off briefly. After turning off the amplifier's power, wait at least 10 seconds before
turning it back on to prevent damaging your speakers (power-on click).
amplifier off briefly. After turning off the amplifier's power, wait at least 10 seconds before
turning it back on to prevent damaging your speakers (power-on click).
The CLIPPING LED will light up when the amplifier has reached its full output and is on
the threshold of distortion. Please turn down the volume if this occurs.
the threshold of distortion. Please turn down the volume if this occurs.
The INPUT SOURCE switch applies the input signal of the left channel to both output
channels.
channels.
Technical data
Input impedance
100 kohm balanced
10 kohm unbalanced
10 kohm unbalanced
Frequency range
20 Hz to 20 kHz
Signal-to-noise ratio
87 dB at 20 W at 4 ohms
Output power
2 x 100 watts at 4 ohms
2 x 70 watts at 8 ohms
2 x 70 watts at 8 ohms
Efficiency
55 % at 4 ohm
63 % at 8 ohms
63 % at 8 ohms
Harmonic distortion
0.01 % at 1 kHz, 5 W
0.1 % at 20 Hz – 20 kHz, 50 W
0.1 % at 20 Hz – 20 kHz, 50 W
Fuse
800 mA slow
Dimensions
482.6 x 175 x 44 mm (19“, 1U)
SINE PA 120, PA 200, PA 460 (English)
9