MINOURA w-300 User Manual

- 2 -

HOW TO SET-UP YOUR W-300

Place the Lower Frame on the level floor and

fully open the Leg. Attach the Plate Leg onto

the bottom of the Lower Frame and secure it

with supplied Knob Bolt. (see Fig. A & B)

(Fig. A)

Be careful not to pinch your finger when you open the leg.

(Fig. B)

Be sure the Plate Leg is installed properly so the Plate Leg

doesn’t come over any guide projections. These are

located on the bottom of the Lower Frame.

(Fig. C)

Install the Foot Adjuster on both legs. (see Fig. C)

(Fig. D)

(Fig. E)

Fix the Height Adjusting Screw at your prefered position.

There are two holes on the Lower Frame. If you choose the

upper hole, the total stand height will be around 1.3 meter. If

you choose the lower hole, the total height will become 10 cm

lower. (see Fig. E)

This adjuster is very important for keeping the stand

stable for your own safety.

Once you place the completed Lower Frame on the floor,

you should check if ALL edges are touching the floor at

same time (see Fig. D) and adjust the length of each Foot

Adjuster if nessessary. Then fix the position by tightening

the lock nut with a 10mm open wrench.

Knob Bolt

Plate Leg