MINOURA w-300 User Manual

- 3 -

The Tool Tray is made of steel plate, so you may be in-

jured if you scratch the edge of the plate with your finger.

Be careful. (see Fig. I)

If the pedal or something hits the tray during crank rota-

tion, move the tray to be behind so its behind the stand

frame.

Insert the Upper Frame into the Lower Frame (see Fig. F) then

fix the position by tightening the supplied small knob bolt and

the spring. (see Fig. G)

Make sure if the direction of the Upper Frame is correct

that the “V” shaped cut-off on the bottom of the Upper

Frame must be on the Height Adjusting Screw.

The wrong direction will not align the frame rotation and

will cause stability issues when you clamp your bike on the

W-300.

(Fig. F)

(Fig. G)

(Fig. H)

Insert the Clamp Jaws to the upper horizontal tube of the

Upper Frame, insert the washer from the backside then

tighten the knob nut. (see Fig. J)

(Fig. J)

If you tighten the knob nut so tight, the clamp jaws may

not rotate easily. The proper amount of tightening should

be so the clamp jaws can rotate smoothly but without any

looseness.

If you purchased the optional “Tool Tray”, insert it to the Upper

Frame before inserting the Upper Frame into the Lower Frame,

and tighten the knob bolt to fix the position and angle. (see Fig.

(Fig. I)