Kofax vrs4 User Manual
Appendix A
108
VRS User’s Manual
Using the RDV Utility
You can use the RDV utility to change the default VRS scanner selection, or to restore
the VRS default settings.
X To launch the RDV utility
1
Locate the RDV folder in your VRS installation and double-click “RDV.exe”
to launch the utility, as shown in Figure A-1.
Figure A-1. RDV Utility Dialog Box
2
If you want to change the default VRS scanner selection, select the desired
scanner from the “Select scanner” list.
3
To update your installation with the original VRS default settings, select
“Restore factory default settings.”
4
Click Apply and then click OK.
Note
There is no need to restore VRS settings to the factory defaults when
you change the default VRS scanner with the RDV utility. Default settings are
automatically updated when you use the RDV utility to change the default
scanner.
When switching to certain scanners, you may receive an error message
similar to the following when you attempt to use the default scanner:
"Missing or Corrupt ISIS.pxw scanner driver file."
This file is only
installed by VRS when the scanner is selected during the setup process. You
can install the missing file by following the procedure below.