Pentax K-5 IIs Operating Guide
172
Usi
ng t
ng t
he
Fl
ash
5
1
Set the wireless mode of the external flash directly connected
to the camera to [MASTER] or [CONTROL].
2
On the wireless remote flash unit, set the wireless flash mode
to [SLAVE] and set the channel to the same channel as the
flash directly connected to the camera. Then, place it at the
desired location.
3
Confirm that both flashes are fully charged and then take
a picture.
Wireless Shooting Using a Combination of External
Flash Units
MASTER
Discharges both the flash directly connected to the
camera and the wireless flash unit as the main flash.
CONTROL
Discharges the flash directly connected to the camera
as a control flash only, not as the main flash.
• The Shake Reduction function is automatically turned off in wireless mode.
• When using multiple AF540FGZ/AF360FGZ external flashes and performing
• When using multiple AF540FGZ/AF360FGZ external flashes and performing
high-speed flash sync shooting in wireless mode, set the flash directly
connected to the camera to high-speed flash sync mode.
• When the wireless mode of the external flash directly connected to the
camera is set to [MASTER] or [21. Flash in Wireless Mode] (p.172) is set to
[On] for the built-in flash, all the flashes will discharge simultaneously.
Changing the Built-in Flash Discharge Method
You can change the built-in flash discharge method used in wireless
mode.
Set in [21. Flash in Wireless Mode] of the [A Custom Setting 3]
menu.
1
On Discharges the built-in flash as a master. (default setting)
2
Off Discharges the built-in flash as a control flash.
HSb (High-speed flash sync) is not available with the built-in flash.
K-5 II_ENG.book Page 172 Wednesday, October 10, 2012 1:20 PM