Panasonic PT-DZ770E Operating Guide
[PROJECTOR SETUP] menu
ENGLISH - 71
Settings
▶
z
The setting will change as follows each time
you press the button.
[ON]
[OFF]
[ON]
Returns the response when the ID
setting is ALL.
[OFF]
Does not return the response
when the ID setting is ALL.
6) Press ▲▼ to select [GROUP].
7) Press ◀▶ to switch [GROUP].
7) Press ◀▶ to switch [GROUP].
▶
z
The setting will change as follows each time
you press the button.
[A]
[B]
[Z]
[A] - [Z]
Controls multiple projectors
simultaneously by sending the ID of
RS-232C.
Set the group from [A] to [Z]. The
projector responds when the ID of
RS-232C matches the setting.
8) Press ▲▼ to select [RESPONSE(ID
GROUP)].
9) Press ◀▶ to switch [RESPONSE(ID
GROUP)].
▶
z
The setting will change as follows each time
you press the button.
[ON]
[OFF]
[ON]
Returns the response when the ID
setting is GROUP.
[OFF]
Does not return the response
when the ID setting is GROUP.
Note
z
Refer to “<SERIAL IN>/<SERIAL OUT> terminal”
(
page 113).
[REMOTE2 MODE]
You can set the <REMOTE 2 IN> terminal.
1) Press ▲▼ to select [REMOTE2 MODE].
2) Press ◀▶ to switch [REMOTE2
2) Press ◀▶ to switch [REMOTE2
MODE].
▶
z
The setting will change as follows each time
you press the button.
[DEFAULT]
[USER]
[DEFAULT]
The pin assignment of the
<REMOTE 2 IN> terminal is used
by the factory default setting of the
projector.
(
page 116)
[USER]
Used to change the setting of the
<REMOTE 2 IN> terminal.
▶
■To set [USER]
3) Select [USER] in Step 2).
4) Press the <ENTER> button.
5) Press ▲▼ to select either [PIN2] or
4) Press the <ENTER> button.
5) Press ▲▼ to select either [PIN2] or
[PIN8] and press ◀▶ to switch the
setting.