Panasonic HLBT62SEPG Operating Guide
42
43
EN
Cleaning and maintenance
Setting the cleaning cycle
Make sure that the oven door is firmly
closed.
In ON mode (see page 16 EN,
Operating modes), press the key
using either or to select one of
the two cleaning cycles between
and
.
To start the cleaning cycle (Pyrolysis),
must be pressed. will light up
to indicate that it is now possible to set
the cycle duration for
.
Press or to increase or
decrease the duration of the cycle
between a minimum of 2 hours and a
maximum of 3 hours (apart from the
cycle where the duration
is set at 2 hours).The selected time
is confirmed 3 seconds after the last
button is pressed.
After the cleaning cycle and time is
confirmed, the lights turn off and Pyro
will appear in the display.
The time remaining to the end of the
cleaning cycle will also be displayed.
About one minute after the cleaning
cycle (Pyrolysis) starts, the door lock
device will be tripped, preventing the
door from being opened. will light
up to indicate that the locking device
has been activated.
At the end of the cleaning cycle the
locking device will remain active until
the temperature inside the oven has
reached a safety threshold. When the
oven has cooled down, collect the
residues from automatic cleaning with
a damp microfibre cloth.
At the end of the cleaning cycle, when
the oven has cooled down, reinsert
the frames by following the removal
procedure in reverse order.
To select a delayed cleaning cycle,
after selecting the duration, proceed
as for a normal programmed cooking
operation, (see page 22 EN, Using
delay start), the principle is the same.
Notes
It is not possible to select any
functions once the door locking
device has been activated. Wait for
to go out.
If it should be necessary to interrupt
the cleaning function, switch the
appliance off completely by pressing
the symbol for 3 seconds.
If the door is open, the cleaning
cycle will not start. Make sure that
the word
is shown in the
display.