Panasonic PT-L735NTE Operating Guide
E
NGLISH
-45
Adjustments
and
settings
Use the F and G buttons on the
projector or remote control unit to
select an item, then press the I or
H buttons to change the setting.
projector or remote control unit to
select an item, then press the I or
H buttons to change the setting.
OSD
ON
The current input name is displayed
in the top-right corner of the screen
when the input signal is changed.
The current input name is displayed
in the top-right corner of the screen
when the input signal is changed.
OFF
Use this setting when you do not
want the current input name to be
displayed.
Use this setting when you do not
want the current input name to be
displayed.
AUTO SEARCH
ON
The input signal will be detected and
selected automatically when the Input
select (RGB, VIDEO) buttons are
pressed for a few seconds. (page 14)
The input signal will be detected and
selected automatically when the Input
select (RGB, VIDEO) buttons are
pressed for a few seconds. (page 14)
OFF
AUTO SEARCH is disabled.
AUTO SEARCH is disabled.
AUTO SIGNAL
This should normally be set to “ON”.
ON
AUTO SETUP will be carried out
automatically when the input signal
is changed. (page 27)
AUTO SETUP will be carried out
automatically when the input signal
is changed. (page 27)
OFF
AUTO SETUP will not function
when the input signal is changed.
AUTO SETUP will not function
when the input signal is changed.
AUTO KEYSTONE
This should normally be set to “ON”.
ON
During automatic setup, the angle of
tilt of the projector is detected and
keystone distortion is corrected
automatically.
During automatic setup, the angle of
tilt of the projector is detected and
keystone distortion is corrected
automatically.
OFF
Use this setting when you do not
want automatic keystone correction
to be carried out during automatic
setup, such as when the screen
itself is at an angle.
Use this setting when you do not
want automatic keystone correction
to be carried out during automatic
setup, such as when the screen
itself is at an angle.
RGB2 SELECT
This setting is used to select the
function of the RGB2 IN/RGB1 OUT
connector.
function of the RGB2 IN/RGB1 OUT
connector.
Option settings
OPTION
OSD
AUTO SEARCH
AUTO SIGNAL
AUTO KEYSTONE
RGB2 SELECT
RGB/YP
B
P
R
VGA60/525P
BLACKBORD
BACK COLOR
NEXT PAGE @
OFF
OFF
OFF
OFF
INPUT
RGB
VGA60
OFF
BLUE
ON
ON
ON
ON
OUTPUT
YP
B
P
R
525P
ON
BLACK
SELECT:[^][@]
ADJUST:[{][}]
ESC:[MENU]
10 H
OPTION
PREVIOUS PAGE ^
FRONT/REAR
DESK/CEILING
FAN CONTROL
LAMP POWER
LAMP RUN TIME
FUNC1
CONTROL KEY
AUTO POWER OFF
FRONT
DESK
STANDARD
LOW
MUTE
OFF
REAR
CEILING
HIGH
HIGH
KEYSTONE
ON
SELECT:[^][@]
ADJUST:[{][}]
ENTER:[ENTER]
ESC:[MENU]
DISABLE
NOTE:
B AUTO SEARCH will not function
B AUTO SEARCH will not function
when the input signal is being
projected.
projected.
(PT-L735NTE only)
AUTO SEARCH will not function
when NETWORK or SD CARD is
selected. NETWORK and
SD CARD cannot be searched even
when these signals are being input.
AUTO SEARCH will not function
when NETWORK or SD CARD is
selected. NETWORK and
SD CARD cannot be searched even
when these signals are being input.