Panasonic MCUL594 Operating Guide

• Unplug the mains lead from electrical outlet.

• Clean exterior using a clean, soft cloth that has been dipped in water and wrung dry.

• Dry wipe after above cleaning.

• DO NOT drip water on the vacuum cleaner.

• DO NOT clean tools in dishwasher or clothes washer.

• Wash tools in warm water, rinse and air dry.

• DO NOT use tools if they are wet.

CLEANING BEATER BAR

CLEANING EXTERIOR AND TOOLS

• Loop new belt around motor shaft and beater bar belt groove.

• Reinstall the beater bar by inserting the end cap of the beater bar to the

slot for both side.

• After reinstalling the beater bar, turn it by hand to make sure that belt is

not twisted or pinched and that all rotating parts turn freely.

• Reinstall lower plate. See “Removing and Installing Lower Plate”.

End Cap

a) Beater Bar for Nozzle

Beater Bar

b) Beater Bar for Mini Turbine Nozzle

Slot

Nozzle

• Clean beater bar for Nozzle and Mini Turbine Nozzle after every five uses.

• Turn vacuum cleaner over, exposing the beater bar for Nozzle.

• Cut off any carpet pile and lint entangled around beater bar for Nozzle

and Mini Turbine Nozzle with a pair of scissors.