Panasonic MCUL594 Operating Guide

If the vacuum cleaner does not seem to have adequate suction, first check if

the dust bin is full or if a filter is clogged.

• Check the hose area.

• Remove hose by grasping the curved wand, twisting, and pulling straight

off. Then, press both hooks and pull out the connection pipe from the

suction inlet.

• Visually inspect the hose and the base area into which the hose is

connected.

• Remove any visible clog.

• Re-connect the connection pipe to the suction inlet.

• Plug in the vacuum cleaner and turn it on.

• Stretch the hose to maximum length and then allow the hose to return to

its storage length.

• Re-connect the curved wand to the curved wand holder.

• Turn off and unplug the vacuum cleaner.

• Remove dust bin and check upper filter and dust intake for clogs.

• If the dust bin, upper filter, dust intake connection and the hose areas

are free of clogs, check the nozzle area.

・

If the above areas are free of clogs, check the Nozzle Hose area.

Disconnect the top of the Nozzle Hose from Curved Wand Holder by

gently pressing the top of the Nozzle Hose. Keep Nozzle Hose straight

and check inside of Nozzle Hose for clogs as shown.

・

After cheking the Nozzle Hose, reconnect the top of the Nozzle Hose to

Curved Wand Holder by gently pressing the top of the Nozzle Hose.

• Return the vacuum cleaner to the upright position before plugging into

an electrical outlet.

REMOVING CLOGS

Curved Wand

Holder

Suction Inlet

Curved Wand

Connection

Pipe

Hook

Nozzle Hose

Nozzle

Upper

Filter

Dust intake

connection