Panasonic MCCG881K Operating Guide

4

A) Floor nozzle
B) Connection pipe
C) Hose
D) Suction regulator

E) Curved wand

F) Telescopic wand

G) Dusting brush

H) Crevice nozzle   

I ) Upholstery nozzle
J) Hose inlet

K) Dust indicator

L) Dust cover

M) ON/OFF Switch pedal

N) Cord rewind pedal

O) Variable power control

P) Exhaust cover   

Q) Plug

R) Paper dust bag (in body)

S) Basket

B-1 

 Insert the connection pipe into the hose inlet until it 
locks. 
When removing the hose, push the two connection 
buttons down while pulling out the connection pipe.
NOTE: Do not bend, pull and step on the hose or put 

anything heavy on it.

B-2 

 Insert the curved wand into the upper end of the 
telescopic wand. 
Twist the telescopic wand so that the round hole will fit 
into the tab on the curved wand.(When removing the 
curved wand, push the tab down while pulling out the 
telescopic wand.) 
Attach the floor nozzle to the other end. (Removal as 
per reverse procedure)

B-3 

 Hold the grip and the extension adjuster and extend 
the telescopic wand to the required length.

C-1 

 Pull out the mains lead and put the plug into the 
socket outlet.

C-2 

 Gently press the center of the switch pedal to turn ON 
the appliance. Press the pedal again to turn it OFF.

C-3 

 Power control
The suction power can be adjusted depending on the 
type of flooring. 
The symbols on the controls indicate the type of use 
the settings are suitable for.

 

 Turn the rotary selector to the desired suction power 
setting. 

C-4 

 Switching between carpet and flooring
Flooring: Press lever A
Carpet: Press lever B

C-5 

 The curved wand of the hose is attached with a 
manual suction regulator, which allows you to 
reduce the suction level easily.

C-6 

 The dusting brush can be set between the telescopic 
wand and the floor nozzle if you want. Remove the 
floor nozzle by pressing the release pedal and you 
can use the dusting brush easily anytime.

C-7 

 After you finish vacuuming, remove the plug from the 
socket outlet and press the cord rewind pedal.
When rewinding the mains lead, press the cord 
rewind pedal by holding the plug so that it does not 
become damaged.

C-8 

 Storage position
Slide the wand holder straight into the wand supporter 
on the under side of the main body.

C-9 

 Park position
For short breaks during vacuuming, slide the wand 
holder straight into the wand supporter on the rear 
side of the main body. 
NOTE:  When you use park position, we suggest that 

you switch the appliance off.