Panasonic MCCG881K Operating Guide

5

Turn the power control to the highest setting and lift the 
nozzle off the floor. If the dust indicator turns red, the paper 
dust bag is full and requires replacing the paper dust bag.
NOTE:  If the paper dust bag is not properly installed, the 

dust cover will not close. Be sure to check that the 
paper dust bag is properly installed before operating 
the appliance, otherwise dust will leak out.
The paper dust bag can easily lay on the dust cover 
packing or clip between the bag collar and the body, 
so be sure to properly extend it into the body of the 
appliance.

D-1 

 Lift the dust cover catch and raise the dust cover until 
it clicks properly.

D-2 

 Remove the basket and throw away the paper dust 
bag.

D-3 

 Set the basket first to the appliance and set a new 
paper dust bag back to the basket.

D-4 

Close the dust cover properly until you hear it click.

D-5 

 Inspect once a month.
Using an old toothbrush or similar tool,clean any dirt 
or lint from the brush.

D-6 

 Wipe with a soft cloth soaked with water.

Follow the procedure written below when the suction power 
is not restored after replacing a new paper dust bag.

D-7 

 Remove the pre-motor filter.

D-8 

 Wash gently with water and then allow to dry in a 
shaded location.

D-9 

 Return the pre-motor filter to its original position.
NOTE:  Make sure you remember to replace the filter. 

If the filter is not installed, it will cause motor 
failure.

 • 

 

Do not wash the filter in a washing machine or dry it 
with a dryer or other source of hot air.

D-10    Exhaust filter, is installed in the rear side of the 

appliance. This filter retains any small dust particles 
which may be present in the expelled air. It is 
advisable to change the filter once or twice a year, 
depending on use. To change the filter, hold the 
exhaust cover (as illustrated) and pull it out. After 
changed the filter, set the exhaust cover to its position 
(as illustrated).

IMPORTANT:  Never use the cleaner without the correct 

filters properly installed. Failure to do so may 
result in damage to the motor.

Check that the appliance is correctly plugged in and that the 
socket outlet is working. If the thermal cut-out device has 
operated, wait until it resets automatically after approximately 60 
minutes. 
If after having checked the above mentioned points, the 
appliance does not work, take it to an Authorized Service Centre 
to be repaired.

• Stop the appliance and unplug from the socket outlet.
•  Check whether the wands, hose and accessories are blocked or 

not. If they are blocked, remove the obstruction.

•  Check whether the paper dust bag is full. If it is full, replace it .
•  Check whether the pre-motor filter or exhaust filter is blocked 

with dust. 
If they are blocked, clean them out or replace them.

Power source

230-240 V~50 Hz

Max. Input

1600 W

Nominal input

1250-1300 W

Dimensions
(W x L x H)

312 mm x 489 mm x 243 mm

Net weight

6.5 kg

Extension wands

Telescopic

Dusting brush

√

Crevice nozzle

√

Upholstery nozzle

√

Paper dust bag (PACK 4/u.)

C-17H 

The model and serial number of this product may be found on the 
nameplate located at the underside of your cleaner. You should 
note the model and serial number in the spaces provided and 
retain this book as a permanent record of your purchase.

Model Number.  .............................................................................
Serial No.  ......................................................................................
Date Purchased.  ...........................................................................
Where Purchased.  ........................................................................