Panasonic CZRWSU2N Operating Guide

16

(EN)

•  Never try to manually move the fl ap (up-down wind direction plate) that is 

operated by the remote controller.

•  When the unit stops, the fl ap (up-down wind direction plate) automatically 

faces downwards.

•  When the unit is in heating standby, the fl ap (up-down wind direction plate) 

faces upwards. Also, bear in mind that the fl ap starts swinging after the 
heating standby mode is released, but the display on the remote controller 
indicates Auto Flap during standby heating as well.

  Setting the Wind Direction
  While the unit is operating, every time 

you press    , the direction the fl ap 
faces changes.

  Setting Flap to Swing
  If you press     to set the fl ap (up-

down wind direction plate) in its most 
downward facing position, and then 
press     again, 

 is displayed 

and the fl ap swings automatically up 
and down.

  Stopping Flap Swing
  If you press     again while the fl ap 

is swinging, you can stop the fl ap from 
swinging and set it in place as 
desired. Thereafter, if you press    , 
you can set the wind direction starting 
from the most upward position.

• 

When the unit is in the Cool or Dry 
mode, the fl ap cannot stop facing 
downwards. If you try to stop the 
fl ap from swinging while it is facing 
downwards, it will continue moving 
until it is in the third position from 
the top.

Please face the fl ap 
(up-down wind 
direction plate) 
downwards. If it faces 
upwards, the warm air 
will not reach the fl oor level.

Please face the fl ap 
(up-down wind 
direction plate) 
upwards. If the plate 
faces downwards, 
condensation may 
form and drip from 
around the air outlet.

Initial setting

Moves constantly

Fan/Heat 
modes

Cool/Dry 
modes

Initial setting

Initial setting

00_OI_303000.indb   16

00_OI_303000.indb   16

2015/02/20   16:23:05

2015/02/20   16:23:05