Panasonic CZRWSU2N Operating Guide

19

(EN)

In both multi and single unit installations, when more than one indoor units 
are installed in the same room with a compatible wireless remote controller, 
addresses can be set up to avoid crosstalk.
By setting the address switches on the receivers and matching them with the 
number of addresses on the remote controller, up to six indoor units can be 
controlled separately with the remote controller. (When using units in a fl exible 
combination or operating multiple units simultaneously, they cannot be 
controlled individually as they are operated at the same time.)
There are separate address settings: receiver addresses for the receivers*

, 

and transmitter addresses for the remote controller.
For more information, please contact the distributor where the product was 
purchased.
•  The setting procedure is different for indoor unit (CZ-RWSK2). (See page 20.)
•  These settings are saved in nonvolatile memory in the remote controller, so 

even when its batteries are changed, the settings do not have to be made 
again.

  CZ-RWSD2N/CZ-RWST3N is of receivers (inside the indoor unit); CZ-

RWSL2N is of an operation panel (inside the indoor unit).

When you press 

 on the remote controller, its current address appears on  

the display. If this address corresponds to the address of a receiver*

, the 

buzzer sounds. (If it is on ALL, the buzzer will always sound.) 
If it is on ALL, it can be operated regardless of receiver addresses. Point the 
remote controller at the receiver you wish to operate and transmit.
*

  CZ-RWSL2N is an operation panel (indoor unit).

from ALL123…6ALL. 

  Set it to the receiver address switch of the indoor unit you wish to operate.

  When you do this, if it corresponds to the receiver’s address setting, the 

buzzer sounds.

00_OI_303000.indb   19

00_OI_303000.indb   19

2015/02/20   16:23:06

2015/02/20   16:23:06