Panasonic CZRWSU2N Operating Guide

2. Names and Operations

(EN)

REMOTE CONTROLLER

One remote controller can control a group of
up to eight indoor units. (See page 17)

1. Operation Display

Displays the operation status.
(The fi gure shows all the
statuses.)
• The auto-fl ap display may be

different, depending on the
installed unit. (See page 16.)

2. Start/Stop button

Pressing this button once starts
and pressing again stops the
operation.

3. Fan speed button
4. Swing/Wind Direction button

5. Timer setting button

Use for operating with a timer.

6. Reset button

Use this button after changing the
batteries.

7. Cover

Press at the top center and then
slide down.

8. Transmitter
9. Remote control sensor

Detects the temperature at the
remote controller when detection
has been switched to the remote
controller by the sensor button.

10. Temperature setting buttons

raises the temperature

setting 1 °C at a time.

lowers the temperature

setting 1 °C at a time.

11. Filter button
CZ-RWSC3

Press to turn off the fi lter lamp on
the receiver.

12. Mode Select button

Press to switch the operation
mode.

13. Ventilation button

Use this when connected to an
aftermarket fan. Pressing this
button starts and stops the fan.
When the air conditioner is started
or stopped, the fan starts or stops
at the same time. (

appears on

the display of the remote
controller when the fan is
operating.)

14. Address button
15. Sensor button

Used this to activate the
temperature sensor on the remote
controller instead of the one on
the indoor unit. The temperature
sensor on the indoor unit is
selected before shipment. At this
time is shown on the display.

16. Clock button

Use this to set the clock.

From this page, the names of
remote controller’s buttons will be
indicated with the above
illustrations.
E.g.: Start/Stop button 

00_OI_303000.indb 8

2015/02/20 16:23:01