Panasonic KXTG8521FX Operating Guide
Programming
32
3
Enter the desired hour and minute
you wish to start this feature. i
M
you wish to start this feature. i
M
L
You can select 24-hour or 12-
hour clock format (“AM” or “PM”)
by pressing /.
hour clock format (“AM” or “PM”)
by pressing /.
4
Enter the desired hour and minute
you wish to end this feature. i
M
you wish to end this feature. i
M
5
{i
c}
L
When the night mode is set, 3 is
displayed.
displayed.
Note:
L
L
To correct a digit, press {<} or {>} to
move the cursor to the digit, then
make the correction.
move the cursor to the digit, then
make the correction.
Changing the start and end time
1
1
(centre of navigator key) i
{
#}{2}{3}{7}
2
Setting the ring delay
This setting allows the handset to ring
during night mode if the caller waits long
enough. After the selected amount of
time passes, the handset rings. If you
select “No Ringing”, the handset
never rings during night mode.
This setting allows the handset to ring
during night mode if the caller waits long
enough. After the selected amount of
time passes, the handset rings. If you
select “No Ringing”, the handset
never rings during night mode.
1
1
(centre of navigator key) i
{
#}{2}{3}{9}
2
{V}
/{^}: Select the desired setting.
i
M i {ic}
Note:
L
L
When the answering system answers
the call, this feature does not work.
(KX-TG8521)
the call, this feature does not work.
(KX-TG8521)
Selecting categories to bypass night
mode
mode
1
1
(centre of navigator key) i
{
#}{2}{4}{1}
2
{V}
/{^}: Select your desired
categories. i t
L
L
“Q” is displayed next to the
selected category numbers.
selected category numbers.
L
To cancel a selected category,
press t again. “Q” disappears.
press t again. “Q” disappears.
3
M i {ic}
Note:
L
L
You can also select the categories in
step 2 as follows:
Press {1} to {9}. i M
step 2 as follows:
Press {1} to {9}. i M
Changing the handset name
Each handset can be given a
customised name (“Bob”, “Kitchen”,
etc.). This is useful when you make
intercom calls between handsets. You
can also select whether or not the
handset name is displayed in standby
mode. The default setting is “Off”. If
you select “On” without entering any
handset name, “Handset 1” to
“Handset 6” is displayed.
customised name (“Bob”, “Kitchen”,
etc.). This is useful when you make
intercom calls between handsets. You
can also select whether or not the
handset name is displayed in standby
mode. The default setting is “Off”. If
you select “On” without entering any
handset name, “Handset 1” to
“Handset 6” is displayed.
1
1
(centre of navigator key) i
{
#}{1}{0}{4}
2
If not required, go to step 3.
3
M
4
{V}
/{^}: Select the desired setting.
i
M 2 times
5
{i
c}
Changing the unit’s region
setting/Resetting the base
unit
1
setting/Resetting the base
unit
1
1
(centre of navigator key) i
{
#}{1}{3}{6}
TG8511_8521FX(e-e).book Page 32 Wednesday, April 14, 2010 5:58 PM