Panasonic RPBTS50E Operating Guide

To establish a wireless connection, register the unit with Bluetooth

 compatible 

devices.

 •Turn on the power, and enable the Bluetooth

 feature.

 •Place the device within 1 m from the unit.

 •Check the device operation in its operation instructions, as required.

 •The unit will start searching 

for the Bluetooth

 device to 

connect to, and the LED on the 

right earphone will blink in blue 

and red alternately. (Only one 

operation after purchase)

 •The MAC address (e.g., 

6C:5A:B5:B3:1D:0F) may be 

displayed before the device 

name is displayed.

 •If prompted for a passkey, input 

“0000 (four zeros)”.

 •If the Bluetooth

 profile selection 

screen appears, select the 

“A2DP” profile. If “A2DP” is not 

supported or if you want to just 

use phone calls, select the “HSP” 

or “HFP” profile. (For details 

on profiles, see “Listening to 

music” and “Making a phone call” 

 •First the LED on the right 

earphone lights in blue and 

repeats on and off. When the 

connection is established, 

blinking pattern will change.

When the unit is turned on, it will 

search for the previously setup 

Bluetooth

 device and automatically 

start connecting to it. First the LED 

on the right earphone lights in blue 

and repeats on and off. When the 

connection is established, blinking 

pattern will change.

Disable the Bluetooth

 feature on the 

previously connected device. Check 

that the unit is turned off. Press and 

hold   for approximately 5 seconds. 

A beep will sound. The unit will start 

searching for other Bluetooth

 device. 

The LED on the right earphone will 

blink in blue and red alternately.

Continue steps 2 and 3.

■

 •If connection to a device is not 

established within approximately 

5 minutes, the unit will be turned off.  

Start from step 1 again.

 •2 or more Bluetooth

 devices cannot 

be connected to the unit at the same 

time.

 •You can pair up to 8 devices with 

this unit. If a 9th device is paired, the 

device with the oldest connection will 

be replaced. To use it, pair it again.

Check the sides (L and R), then wear the earphones from behind your neck and 

hook over both ears, and bend the clip to adjust. Move the cord adjuster towards 

the back of your head.

Follow the steps below for the first time to ensure the most comfortable and 

secure fit.