Panasonic DMREZ28 Operating Guide

25

RQT9118

 

 

 

 

 

 

Insert a disc with enough remaining blank space 
(

➔ 14).

 If the disc is protected, release protection

(

➔ 48).

Connect a satellite receiver to this unit’s input 
terminals (

➔ 9).

When the output signal from the external 
equipment is NTSC, change the “TV System” to 
“NTSC” in the Setup menu (

➔ 55).

This unit cannot record NTSC signals to discs that 
already have PAL signal recordings.

•

•

•

•

 

With the unit stopped

 

 to select “AV2” for the 

 

satellite receiver you have 
connected.

 

 to select the recording 

 mode.

 Select the channel on the satellite 

receiver.

 

 to start recording.

 Tips

To skip unwanted parts
Press [h PAUSE] to pause recording. (Press again to restart 
recording.)

To stop recording
Press [g STOP].

To record programmes from a SKY Digital STB/satellite 
receiver using timer programming

Insert a disc with enough remaining blank space 
(

➔ 14).

 If the disc is protected, release protection

(

➔ 48).

Make sure you connect the AV2 input terminal of 
this unit to “VCR Scart Terminal” of a SKY Digital 
STB/satellite receiver with a 21-pin scart cable 
(

➔ 9).

Set the “AV2 Input” and “Ext Link” to match the 
connected equipment in the Setup menu (

➔ 55).

•

•

•

•

 Make timer programming on SKY 

Digital STB/satellite receiver.

Refer to the equipment’s operating 
instructions.

–

 

The unit turns off and “EXT-L” lights on the 
unit’s display to indicate timer recording 
standby has been activated.
While the unit is in EXT LINK standby mode 
or recording, most operations on this unit are 
prohibited ([; OPEN/CLOSE], [8] etc.).
When you operate, press [EXT LINK] to 
cancel EXT LINK standby mode or recording 
(The unit turns on and “EXT-L” disappears.).

–

–

 Tips

To cancel the external control
Press [EXT LINK] to stop recording or to cancel linked timer
recording standby (The unit turns on and “EXT-L” disappears.).
Manual timer recordings (➔ 27)

 Notes

In order to prevent accidental operation, press [EXT LINK] to cancel 
the setting after recording is finished.
This function does not work when “TV System” is set to “NTSC” in 
the Setup menu (

➔ 55).

This function does not work with some equipment. Refer to the 
equipment’s operating instructions.
The beginnings of recordings may not be recorded correctly in 
some cases.
When “Ext Link” is set to “Ext Link 2”, this function does not work if 
the input signal is NTSC system.
Programmes are recorded as one title on this unit when the end 
time of the earlier timer recording and the start time of the later 
timer recording are close to each other.

 To divide the titles, go to “Divide Title” (

➔ 42).

While the unit is in EXT LINK standby mode or recording, AV1 
output terminal outputs the signal which is input from the AV2 input 
terminal irrespective of “AV1 Output” setting (

➔ 55).

•

•

•

•

•

•

•

DMR-EZ28-EB _RQT9118-B.indb   25

DMR-EZ28-EB _RQT9118-B.indb   25

2008/04/04   10:32:00

2008/04/04   10:32:00