Panasonic DMR-EZ25EB Operating Guide

î Check the connection to the household mains socket.

î The unit is malfunctioning. 

î One of the unit’s safety devices may have been activated.

!

Press  

  to switch on the unit.

î The unit is currently recording.

!

With the unit switched off, press STOP    and 

 on the unit at the same time 

and hold for about 5 seconds. Contact your dealer. 

CH  

î The unit is hot and switches to Standby mode for safety reasons. 
î Wait approx. 30 minutes until the message disappears. Place the unit in a well 

ventilated location. Do not block the vents of the unit. 

!

Switch the unit to Standby mode with  

 . 

If the unit does not switch to Standby mode, press  

 for approx. 10 seconds or 

unplug it for a minute and then plug it back in.

!

Press  

  to switch on the unit. If this does not solve the problem, contact 

customer service with the displayed error code.

î The unit is not functioning properly. 

!

Switch the unit off and back on again. 
If this does not solve the problem, contact customer service.

î The unit is in Standby mode for a Timer programming via external units. EXT-L 

appears in the display.

!

Press EXT LINK to switch off recording standby mode.

!

To cancel a recording prematurely, stop the transfer of the recording signal on the 
external unit.

!

Press EXT LINK to switch off recording standby mode.

î A problem occurred during recording or playback of a disc. 

The unit is not defective, but is performing a restore procedure. 
Wait until the error message disappears from the display. 

î The numbers following H, U or F indicate the status of the unit.

î The above procedure cannot be executed if the child lock feature is activated.

!

Switch off the child lock feature.

Should problems occur, please try to resolve them by referring to the following 
descriptions. If this does not help, you should contact your dealer or customer 
service.

Normal disc rotating sounds, atmospheric interference during reception, 
picture interference while fast-forwarding, and imited reception of the satellite 
programmes are not signs of a defective unit. If a disc cannot be played due to 
poor quality, try it again with a disc from Panasonic.

î

The connected unit is not suitable for connection to HDMI.

î
î

.

î

.

î

The HDMI connection does not work perfectly.
The connected unit is not suitable for connection to HDMI
The HDMI cable is too long
The HDMI cable is broken.

î

 

The unit has found an error during recording or playback without an inserted disc. 
The unit proceeds with the recovery procedure.
This procedure restores the normal operating mode. The unit is not defect. Please 
wait until the message goes off.