Panasonic DMR-EZ25EB Operating Guide
67
No picture.
!
Press and hold STOP and
on the unit at the same time for more than
5 seconds. The function is switched to half-picture (INTERLACE).
PLAY/x1.3
Television reception worsens
when the unit is connected.
î
You may need to use a signal amplifier.
Check the antenna connection and the alignment of your antenna.
The TV picture format is not
set correctly.
î Check the [TV Aspect] setting in the Connection Setup menu.
No on-screen messages.
î Change the [On-Screen Messages] setting the Display Setup menu.
No sound. Distorted sound.
Volume set to quiet.
î Check the connections.
î If you connected an amplifier, check the input mode.
î Switch off the V.S.S. function if it causes problems.
î Switch off the V.S.S. function if it causes problems.
It is not possible to hear the
desired sound type.
!
Press DISPLAY to select the desired sound type.
!
Change the appropriate setting in the Sound Setup menu.
The sound cannot be set for
stereo or NICAM broadcasts.
î Connect external unit with audio cables even if you use a digital connection.
î You can change the sound type when using DVD-RAM.
î You can change the sound type when using DVD-RAM.
PICTURE
SOUND
There is picture interference.
î The sound cannot be switched on some discs.
î Check the connection to the TV, e.g. AV1.
î The [TV System] setting does not match that on the disc.
!
In STOP mode, press and hold STOP and OPEN/CLOSE on the unit for more
than 5 seconds. This switches the unit from PAL to NTSC or vice versa.
than 5 seconds. This switches the unit from PAL to NTSC or vice versa.
No functions.
î An incorrect remote control code was selected.
î Check the batteries.
î Point the remote control at the sensor on the unit.
î The child lock feature has been activated.
î Check the batteries.
î Point the remote control at the sensor on the unit.
î The child lock feature has been activated.
The TV cannot be operated.
î An incorrect remote control code was selected.
REMOTE CONTROL
î No time. Set the time in the Others [Clock] Setup menu.
The display light is weak.
î Change the [FL Display] setting in the Display Setup menu.
DISPLAY
"0:00" blinks on the unit display.
8
55
î The PROGRESSIVE output is activated, but the connected TV is not
progressive-capable.
Page
55
44
44
43
40
8
51
51
56
59
59
59
59
5
43
Poor picture in spite
of good signal quality.
î
Overmodulation makes the signal strength display go to red.
!
Readjust the picture with your room aerial until the picture quality improves.
If you need help
59