Panasonic dmre60 Instruction Manual

Timer recording (continued)

ªIf “– –” appears under “Name” after entering a 

Name stands for Programme Position/TV Station Name.
Normally, the name of the TV station or the number of the 
programme position is displayed under “Name”.
However, if the TV station information was not automatically set 
during Preset Download or Auto Setup due to adverse reception 
conditions, the “– –” indication appears instead.
In such a case, follow the operation steps below to correct it.

3, 4] (10) repeatedly to select the programme 

After you have entered the information of a TV station, it remains 
stored in the unit’s memory, and you do not need to enter it again 
in the future.

Note
≥The built-in clock employs 24-hour system.
≥The actual time recorded may be longer than the programme 

itself when television programmes are recorded using S

HOW

V

IEW

.

≥“Invalid Entry” is displayed when you enter the wrong code. 

Reenter the code.

≥“PROG FULL” is displayed in the unit’s display if there are already 

16 items programmed. Delete unnecessary items (page 29).

≥The remaining time displayed is calculated based on the current 

recording mode.

≥When recording more than one programme in a row, for DVD-

RAM the first few seconds, and for DVD-R about the first 30 
seconds of all programmes from the second one onwards will not 
be recorded.

≥Recording is not possible unless you set “Disc Protection” in 

“DISC INFORMATION” to “Off”. (page 32)

≥You can not record to a disc if the write protect tab on a cartridge 

disc is set to protect. Release this before operation (page 70).

≥Even if the unit is put in the timer recording standby mode or the 

timer recording is being performed, you can play a programme.

≥If the unit is not put in the timer recording standby mode at the 

latest 10 minutes before the programmed timer recording starting 

time, the [

] flashes on the unit display. In this case, press the 

[

,  TIMER] 

(14) button to put the unit in the timer recording 

standby mode.

[RAM] [DVD-R]

You can set your own programming conditions (up to 16 
programmes).

Preparation
≥Switch [DVD, TV] (19) to “DVD”.
≥Ensure that this unit’s clock is set correctly.
≥Insert a disc for recording (make sure there is enough room for 

the programme you are going to record plus a little extra).

(13).

≥The Timer Programme List screen appears.

A line that is ready for programming is highlighted.

≥The Timer Programme Correction screen appears.

1] (10) to move through the items and change 

3, 4] (10).

≥The current settings are shown each time you press [1] (10).≥You may use the numeric buttons (4) to enter “Name”, 

“Date”, “Start” and “Stop”.

≥Name (Programme Position/TV Station Name)
≥Date

Current date

!)the day before one month later!)Daily 

(Sunday to Saturday)

!)Daily (Monday to 

Saturday)

!)Daily (Monday to Friday)!)Weekly 

(Sundays)

!)…!)Weekly (Saturdays)!)Current date…

≥Start (start time)/Stop (finish time)

The time increases or decreases in 30-minute increments if 
you hold the button.

≥Mode (Recording mode)

XP

!)FR!)EP!)LP!)SP!)XP… (page 21)

≥VPS/PDC

ON

!)OFF (– – –) (page 27)

≥Title

Select “Title” and press [ENTER] 

(10), then refer to page 31 

for entering title.

DVD(PAL).book  28 ページ  ２００３年５月１日　木曜日　午後１０時４３分