Panasonic DMCSZ1EG Operating Guide
- 65 -
Snimanje
[Sensitivity] (Osjetljivost)
Primjenjivi načini rada:
Ova funkcija omogućuje podešavanje optimalne osjetljivosti na svjetlost (ISO
osjetljivost). Podešavanjem na veću vrijednost omogućuje se snimanje fotografija čak i
u mračnim prostorima, bez straha da će fotografije ispasti tamne.
Postavke
Opis postavki
([i.ISO])
ISO osjetljivost podešava se u skladu s kretanjem objekta
i svjetlinom.
• Maksimalno [1600]
[100]
ISO osjetljivost fiksno je postavljena na različite postavke
[200]
[400]
[800]
[1600]
[400]
[800]
[1600]
[100] [1600]
Lokacija snimanja
(preporučeno)
Kad je vani svijetlo
Kad je mrak
Brzina zatvarača
Sporo
Brzo
Buka
Manje
Pojačano
Podrhtavanje objekta
Pojačano
Manje
■
Funkcija [ ] (Inteligentna kontrola ISO osjetljivosti)
Fotoaparat prepoznaje kretanje objekta i automatski podešava optimalnu ISO osjetljivost i
brzinu zatvarača radi prilagodbe u odnosu na kretnje objekta i svjetline prizora kako bi se
smanjile vibracije.
• Brzina zatvarača nije fiksno postavljena kada se okidač pritisne dopola. Ona se
neprekidno mijenja sve dok okidač ne pritisnete do kraja da bi odgovarala kretnjama
objekta.
Napomena
• Detalje o rasponu fokusa bljeskalice kada je podešena postavka [ ] potražite na
str. 51
.
• ISO osjetljivost automatski se postavlja u sljedećim uvjetima.
- kod snimanja videozapisa
- Kada je funkcija [Burst] postavljena na [ ] ili [ ]
Recording
- 60 -
∫
The available flash range
∫
Shutter speed for each flash setting
¢
1
The shutter speed changes depending on the
[Stabilizer]
setting.
¢
2 When [
] in [Sensitivity] is set.
•
¢
1, 2: The shutter speed becomes a maximum of 1 second in the following cases.
–
When the Optical Image Stabiliser is set to [OFF].
–
When the camera has determined that there is very little jitter when the Optical Image
Stabiliser is set to [ON].
•
In Intelligent Auto Mode, shutter speed changes depending on the identified scene.
•
The shutter speed for [Sports], [Snow], [Beach & Surf], [Underwater] and Scene Modes will be
different from above table.
Note
•
If you bring the Flash too close to an object, the object may be distorted or discoloured by the
heat or lighting from the Flash.
•
Recording a subject from too close, or without sufficient flash will not provide the appropriate
level of exposure, and may result in a picture that is too white or dark.
•
When the Flash is being charged, the Flash icon blinks red, and you cannot take a picture even
when you press the shutter button fully.
•
If recording a subject without sufficient flash, the White Balance may not be properly adjusted.
•
The effects of the flash may not be adequately achieved under the following conditions.
–
When [Burst] in the [Rec] menu is set to [
]
–
When the shutter speed is too fast
•
It may take time to charge the Flash if you repeat taking a picture. Take a picture after the
access indication disappears.
•
The Red-Eye Reduction effect differs between people. Also, if the subject is far away from the
camera or was not looking at the first Flash, the effect may not be evident.
Wide
Tele
In [
] in
[Sensitivity] 30 cm (0.98 feet) to 4.4 m (14 feet)
1 m (3.3 feet) to 3 m (9.8 feet)
Flash setting
Shutter speed (Sec.)
Flash setting
Shutter speed (Sec.)
‡
1/60 to 1/1300
1 or 1/8 to 1/1300
¢
1
1 or 1/4 to 1/1300
¢
2
‰
Œ
Recording
- 60 -
∫
The available flash range
∫
Shutter speed for each flash setting
¢
1
The shutter speed changes depending on the
[Stabilizer]
setting.
¢
2 When [
] in [Sensitivity] is set.
•
¢
1, 2: The shutter speed becomes a maximum of 1 second in the following cases.
–
When the Optical Image Stabiliser is set to [OFF].
–
When the camera has determined that there is very little jitter when the Optical Image
Stabiliser is set to [ON].
•
In Intelligent Auto Mode, shutter speed changes depending on the identified scene.
•
The shutter speed for [Sports], [Snow], [Beach & Surf], [Underwater] and Scene Modes will be
different from above table.
Note
•
If you bring the Flash too close to an object, the object may be distorted or discoloured by the
heat or lighting from the Flash.
•
Recording a subject from too close, or without sufficient flash will not provide the appropriate
level of exposure, and may result in a picture that is too white or dark.
•
When the Flash is being charged, the Flash icon blinks red, and you cannot take a picture even
when you press the shutter button fully.
•
If recording a subject without sufficient flash, the White Balance may not be properly adjusted.
•
The effects of the flash may not be adequately achieved under the following conditions.
–
When [Burst] in the [Rec] menu is set to [
]
–
When the shutter speed is too fast
•
It may take time to charge the Flash if you repeat taking a picture. Take a picture after the
access indication disappears.
•
The Red-Eye Reduction effect differs between people. Also, if the subject is far away from the
camera or was not looking at the first Flash, the effect may not be evident.
Wide
Tele
In [
] in
[Sensitivity] 30 cm (0.98 feet) to 4.4 m (14 feet)
1 m (3.3 feet) to 3 m (9.8 feet)
Flash setting
Shutter speed (Sec.)
Flash setting
Shutter speed (Sec.)
‡
1/60 to 1/1300
1 or 1/8 to 1/1300
¢
1
1 or 1/4 to 1/1300
¢
2
‰
Œ
Recording
- 60 -
∫
The available flash range
∫
Shutter speed for each flash setting
¢
1
The shutter speed changes depending on the
[Stabilizer]
setting.
¢
2 When [
] in [Sensitivity] is set.
•
¢
1, 2: The shutter speed becomes a maximum of 1 second in the following cases.
–
When the Optical Image Stabiliser is set to [OFF].
–
When the camera has determined that there is very little jitter when the Optical Image
Stabiliser is set to [ON].
•
In Intelligent Auto Mode, shutter speed changes depending on the identified scene.
•
The shutter speed for [Sports], [Snow], [Beach & Surf], [Underwater] and Scene Modes will be
different from above table.
Note
•
If you bring the Flash too close to an object, the object may be distorted or discoloured by the
heat or lighting from the Flash.
•
Recording a subject from too close, or without sufficient flash will not provide the appropriate
level of exposure, and may result in a picture that is too white or dark.
•
When the Flash is being charged, the Flash icon blinks red, and you cannot take a picture even
when you press the shutter button fully.
•
If recording a subject without sufficient flash, the White Balance may not be properly adjusted.
•
The effects of the flash may not be adequately achieved under the following conditions.
–
When [Burst] in the [Rec] menu is set to [
]
–
When the shutter speed is too fast
•
It may take time to charge the Flash if you repeat taking a picture. Take a picture after the
access indication disappears.
•
The Red-Eye Reduction effect differs between people. Also, if the subject is far away from the
camera or was not looking at the first Flash, the effect may not be evident.
Wide
Tele
In [
] in
[Sensitivity] 30 cm (0.98 feet) to 4.4 m (14 feet)
1 m (3.3 feet) to 3 m (9.8 feet)
Flash setting
Shutter speed (Sec.)
Flash setting
Shutter speed (Sec.)
‡
1/60 to 1/1300
1 or 1/8 to 1/1300
¢
1
1 or 1/4 to 1/1300
¢
2
‰
Œ
Recording
- 82 -
Applicable modes:
This allows the Sensitivity to light (ISO sensitivity) to be set. Setting to a higher figure
enables pictures to be taken even in dark places without the resulting pictures coming out
dark.
∫
About [
] (Intelligent ISO sensitivity control)
The camera
detects movement of the subject and then
automatically sets the optimum ISO
sensitivity and shutter speed to suit the movement of the subject and brightness of the
scene to minimise the jitter of the subject.
•
The shutter speed is not fixed when the shutter button is pressed halfway. It is continuously
changing to match the movement of the subject until the shutter button is pressed fully.
Note
•
For the focus range of flash when [
] is set, refer to
P60
.
•
The ISO sensitivity is automatically set under the following conditions.
–
When recording motion pictures
–
When [Burst] in the [Rec] menu is set to [
] or [
]
[Sensitivity]
Settings
Description of settings
[
]
([i.ISO])
The ISO sensitivity is adjusted according to the movement of the
subject and the brightness.
•
Maximum [1600]
[100]
The ISO sensitivity is fixed to various settings.
[200]
[400]
[800]
[1600]
[400]
[800]
[1600]
[100]
[1600]
Recording location
(recommended)
When it is light (outdoors)
When it is dark
Shutter speed
Slow
Fast
Noise
Less
Increased
Jitter of the subject
Increased
Less
Recording
- 56 -
Note
•
The indicated zoom magnification is an approximation.
•
“EZ” is an abbreviation of “Extra Optical Zoom”. It is possible to take more magnified pictures
with the optical zoom.
•
When using the Digital Zoom, we recommend using a tripod and the Self-timer
(P62)
for taking
pictures.
•
For details about using the zoom while recording motion pictures, refer to
P36
.
•
The Extra Optical Zoom cannot be used in the following cases:
–
In Macro Zoom Mode
–
In [High Sens.] in Scene Mode
–
When [Burst] in the [Rec] menu is set to [
] or [
]
–
When recording motion pictures
•
The Intelligent Zoom cannot be used in the following cases:
–
In Macro Zoom Mode
–
In [High Sens.] in Scene Mode
–
When [Burst] in the [Rec] menu is set to [
] or [
]
•
[Digital Zoom] cannot be used in the following cases:
–
In Intelligent Auto Mode
–
In Miniature Effect Mode
–
In [High Sens.] in Scene Mode
–
When [Burst] in the [Rec] menu is set to [
] or [
]
Recording
- 56 -
Note
•
The indicated zoom magnification is an approximation.
•
“EZ” is an abbreviation of “Extra Optical Zoom”. It is possible to take more magnified pictures
with the optical zoom.
•
When using the Digital Zoom, we recommend using a tripod and the Self-timer
(P62)
for taking
pictures.
•
For details about using the zoom while recording motion pictures, refer to
P36
.
•
The Extra Optical Zoom cannot be used in the following cases:
–
In Macro Zoom Mode
–
In [High Sens.] in Scene Mode
–
When [Burst] in the [Rec] menu is set to [
] or [
]
–
When recording motion pictures
•
The Intelligent Zoom cannot be used in the following cases:
–
In Macro Zoom Mode
–
In [High Sens.] in Scene Mode
–
When [Burst] in the [Rec] menu is set to [
] or [
]
•
[Digital Zoom] cannot be used in the following cases:
–
In Intelligent Auto Mode
–
In Miniature Effect Mode
–
In [High Sens.] in Scene Mode
–
When [Burst] in the [Rec] menu is set to [
] or [
]
Preparation
- 18 -
∫
Playback
Note
•
The operating times and number of recordable pictures will differ according to the
environment and the operating conditions.
For example, in the following cases, the operating times will shorten and the number of
recordable pictures is reduced:
–
At low temperature or in cold locations such as ski resorts or at high altitude
¢
¢
Residual image may show on the LCD display when in use. The battery performance
will decrease, so keep the camera and spare batteries warm by placing them in a
warm place such as inside your cold protection gear or clothing. Performance of
batteries and LCD monitor will restore to normal when the temperature returns to
normal.
–
When using [LCD Mode].
–
When operations such as flash and zoom are used repeatedly.
•
When the operating time of the camera becomes extremely short even after properly charging
the battery, the life of the battery may have expired. Buy a new battery.
Playback time
Approx. 240 min
- 65 -
Recording
Applicable modes:
This allows the Sensitivity to light (ISO sensitivity) to be set. Setting to a higher figure
enables pictures to be taken even in dark places without the resulting pictures coming out
dark.
∫
About [
] (Intelligent ISO sensitivity control)
The camera
detects movement of the subject and then
automatically sets the optimum ISO
sensitivity and shutter speed to suit the movement of the subject and brightness of the
scene to minimise the jitter of the subject.
•
The shutter speed is not fixed when the shutter button is pressed halfway. It is continuously
changing to match the movement of the subject until the shutter button is pressed fully.
Note
•
For the focus range of flash when [
] is set, refer to
P51
.
•
The ISO sensitivity is automatically set under the following conditions.
–
When recording motion pictures
–
When [Burst] is set to [
] or [
]
[Sensitivity]
Settings
Description of settings
[
] ([i.ISO])
The ISO sensitivity is adjusted according to the movement of the
subject and the brightness.
•
Maximum [1600]
[100]
The ISO sensitivity is fixed to various settings.
[200]
[400]
[800]
[1600]
[400]
[800]
[1600]
[100]
[1600]
Recording location
(recommended)
When it is light (outdoors)
When it is dark
Shutter speed
Slow
Fast
Noise
Less
Increased
Jitter of the subject
Increased
Less