Intel X3370 INXEON3370 Data Sheet

Datasheet

89

The system can generate a STPCLK# while the processor is in the HALT Power Down 

state. When the system deasserts the STPCLK# interrupt, the processor will return 

execution to the HALT state.

While in HALT Power Down state, the processor will process bus snoops.

Extended HALT is a low power state entered when all processor cores have executed 

the HALT or MWAIT instructions and Extended HALT has been enabled via the BIOS. 

When one of the processor cores executes the HALT instruction, that logical processor 

is halted; however, the other processor continues normal operation. The Extended 

HALT Powerdown must be enabled via the BIOS for the processor to remain within its 

specification.

The processor will automatically transition to a lower frequency and voltage operating 

point before entering the Extended HALT state. Note that the processor FSB frequency 

is not altered; only the internal core frequency is changed. When entering the low 

power state, the processor will first switch to the lower bus ratio and then transition to 

the lower VID.

While in Extended HALT state, the processor will process bus snoops.

The processor exits the Extended HALT state when a break event occurs. When the 

processor exits the Extended HALT state, it will first transition the VID to the original 

value and then change the bus ratio back to the original value.

When the STPCLK# signal is asserted, the Stop Grant state of the processor is entered 

20 bus clocks after the response phase of the processor-issued Stop Grant 

Acknowledge special bus cycle.

Since the GTL+ signals receive power from the FSB, these signals should not be driven 

(allowing the level to return to V

TT

) for minimum power drawn by the termination 

resistors in this state. In addition, all other input signals on the FSB should be driven to 

the inactive state.

RESET# will cause the processor to immediately initialize itself, but the processor will 

stay in Stop-Grant state. A transition back to the Normal state will occur with the de-

assertion of the STPCLK# signal.

A transition to the Grant Snoop state will occur when the processor detects a snoop on 

the FSB (see 

).

While in the Stop-Grant State, SMI#, INIT# and LINT[1:0] will be latched by the 

processor, and only serviced when the processor returns to the Normal State. Only one 

occurrence of each event will be recognized upon return to the Normal state.

While in Stop-Grant state, the processor will process a FSB snoop. 

The Extended HALT Snoop State is used in conjunction with the Extended HALT state. If 

Extended HALT state is not enabled in the BIOS, the default Snoop State entered will 

be the HALT Snoop State. Refer to the sections below for details on HALT Snoop State, 

Grant Snoop State and Extended HALT Snoop State.