Panasonic KX-HCM10 Operating Guide

Operating Instructions

83

Update Firmware window allows the user to install the latest version of the 
Network Camera internal operating system. In most cases, this will never be 
necessary. The present firmware has undergone extensive testing and was found 
to be very reliable. Changes may be necessary to accommodate new operating 
systems or new web browsers that are not shown on Page 9. In those cases, 
Update Firmware would be available from Network Camera Technical Support 
Site at http://www.kmelink.net/ipproducts/us/download/index.html. Please 
check the current firmware version on the Setup Page on Page 53.

•

Do not turn off the power during Update Firmware. If the operation of 
Update Firmware is stopped, please refer to Section 
4.2

•

Buffering Images are erased when performing Update Firmware.

Download the proper firmware from the Network Camera Technical Support 
Site mentioned above.

If the Network Camera is accessible from the Internet, temporarily disable the 
access and connect the Network Camera directly to the PC. This will eliminate 
any interruption during the Update Firmware.

When the Network Camera uses the DHCP function, please change the 
Internet connection from DHCP to Static in Network window. Please refer 
to Page 57 for the network parameters.

Enter "http://IP Address (or URL):Port No./config.html" on the web browser 
and press [Enter] of the keyboard. When port no. is 80 (default), you do not 
need to enter port no. Setup Page appears.

Ethernet hub

(Without Ethernet hub, you should use category 5 cross cable.)

Router

or

or

(Category 5 straight cable)