Panasonic CUE18HKE Operating Guide

Page of 10
8
   CARE & CLEANING
  CARE & CLEANING
WASHING  INSTRUCTIONS
WASHING  INSTRUCTIONS
•  Do not use benzene, thinner or scouring powder.
•  Use only soap (  pH7) or neutral household detergent.
•  Do not use water hotter than 40°C.
  HINTS
 HINTS
• Clean the fi lter regularly for best performance and to 
reduce power consumption.
•  Please consult your nearest dealer for seasonal 
inspection.
FOR SEASONAL INSPECTION AFTER EXTENDED 
FOR SEASONAL INSPECTION AFTER EXTENDED 
NON-USE
NON-USE
•  Checking of remote control batteries.
•  No obstruction at air inlet and air outlet vents.
•  After 15 minutes of operation, it is normal to have the 
following temperature difference between air inlet and air 
outlet vents: 
Cooling: ≥ 8°C 
Heating: ≥ 14°C
NON SERVICEABLE CRITERIAS
NON SERVICEABLE CRITERIAS
TURN OFF POWER SUPPLY then CALL Authorized 
Distributor under the following conditions:
•  Abnormal noise during operation.
•  Water/foreign particles have entered the remote control.
•  Water leaks from Indoor unit.
•  Circuit breaker switches off frequently.
•  Power cord becomes unnaturally warm.
•  Switches or buttons are not functioning properly.
FOR EXTENDED NON-USE
FOR EXTENDED NON-USE
•  Activate Heat mode for 2~3 hours to remove moisture left in 
the internal parts thoroughly.
•  Turn off the power supply.
•  Remove the remote control batteries.
Wipe the unit gently with a soft, 
dry cloth.
INDOOR UNIT
INDOOR UNIT
ALUMINIUM FIN
ALUMINIUM FIN
• Clean the fi lters regularly.
• Wash/rinse the fi lters gently with water 
to avoid damage to the fi lter surface.
• Dry the fi lters thoroughly under 
the shade, away from fi re or direct 
sunlight.
•  Replace any damage fi lter.
e-ion FILTERS
e-ion FILTERS
Clean with dry cotton bud.
•  Active e-ion generator 
cleaning is recommended 
every 6 months.
ACTIVE e-ion GENERATOR
ACTIVE e-ion GENERATOR
ACTIVE e-ion POWER MODULE
ACTIVE e-ion POWER MODULE
FRONT PANEL
FRONT PANEL
Raise and pull to remove. Wash 
gently and dry.
Remove
Remove
CAUTION
• Switch off the power supply before cleaning.
• Do not touch the aluminium fi n, sharp parts may cause injury.