Panasonic CZ256ESMC2 Operating Guide
74
6 Using the System
While this message is visible, no other operations can be performed except OK and Cancel .
Touch OK to perform cut-off processing with the system in the state before the change.
Touch Cancel if you do not need to perform cut-off processing.
Touch Cancel if you do not need to perform cut-off processing.
Touch OK to check the new confi guration.
If you select OK here, the current system confi guration is
re-checked and the results are confi rmed.
If you do not need to do this, select Cancel .
re-checked and the results are confi rmed.
If you do not need to do this, select Cancel .
If the system has changed because of a mistake, return the system to its former state and then
touch Cancel . You should also touch Cancel here if you mistakenly selected Cancel in the
previous message, even though the system cut-off processing should have been done. This
returns you to the fi rst alarm message, where you can perform cut-off processing.
While this message is visible, no other operations can be performed except OK and Cancel .
touch Cancel . You should also touch Cancel here if you mistakenly selected Cancel in the
previous message, even though the system cut-off processing should have been done. This
returns you to the fi rst alarm message, where you can perform cut-off processing.
While this message is visible, no other operations can be performed except OK and Cancel .
6.9 System Confi guration Changes
An alarm message like the following appears when a system confi guration change (or the
possibility of a confi guration change) is detected.
If the system continues to operate after its confi guration has changed, distribution ratios and other
data will be totally inaccurate. For this reason, cut-off processing must be done with the system
in the state before the change. The following message is displayed to ask you to confi rm the
processing.
possibility of a confi guration change) is detected.
If the system continues to operate after its confi guration has changed, distribution ratios and other
data will be totally inaccurate. For this reason, cut-off processing must be done with the system
in the state before the change. The following message is displayed to ask you to confi rm the
processing.
Operation procedure for each case is as follows.
6.9.1 When a system confi guration change detected
This alarm message is displayed in cases such as the following.
1
“Check system Confi guration” was made after removing
the outdoor and indoor units.
2
“Check system Confi guration” was made after starting the
unit and found that it was different from the previous one
in confi guration.
in confi guration.
* “Confi guration” includes not only the number of units and
address but also indoor unit capacity, main/sub unit setting,
and presence/absence of an electric heater.
and presence/absence of an electric heater.
Here you can see the link system where the confi guration has
been changed.
been changed.
CZ-256ESMC2_EN.indb 74
CZ-256ESMC2_EN.indb 74
3/31/2011 2:03:26 PM
3/31/2011 2:03:26 PM