Panasonic DPMC210 Operating Guide
1. Introduction and Installation
10
Detailed operating instructions are on the CD-ROM.
Connections and Setup
1.3 Connections
Caution:
L
When you operate this product, the power outlet
should be near the product and easily
accessible.
should be near the product and easily
accessible.
Note:
L
If any other device is connected to the same
telephone line, this unit may disturb the network
condition of the device.
telephone line, this unit may disturb the network
condition of the device.
Using surge protectors
L
The warranty does not cover damage due to power
line surges or lightning. For additional protection, we
recommend using a surge protector (
line surges or lightning. For additional protection, we
recommend using a surge protector (
j).
Using network router/network hub
L
We recommend using network routers/network hubs
(
(
6) under secure network environments. Consult
your network administrator for firewall settings, etc.
L
The warranty does not cover damage due to security
problems or any disadvantages relating to it.
problems or any disadvantages relating to it.
1.4 Turning the power switch ON
Turn the power switch to the ON position (
1).
1.5 Dialing mode
If you cannot dial, change this setting according to your
telephone line service.
telephone line service.
1
{
Menu}
2
Press {#}{1}{2}{0} to display “
Dialing Mode”.
3
Press {1} or {2} to select the desired setting.
{
{
1} “
Pulse”: For rotary/pulse dial service.
{
2} “
Tone” (default): For tone dial service.
4
{
Set}
5
Press {Menu} to exit.
1 Power cord
L
Connect to a power outlet
(120 V, 60 Hz).
(120 V, 60 Hz).
2 Telephone line cord
L
Connect to a single telephone line jack (RJ11).
3 [EXT] jack
L
You can connect an answering machine or an
extension telephone. Remove the stopper if
attached.
extension telephone. Remove the stopper if
attached.
4 Answering machine (not supplied)
5 To the internet
6 Network router/Network hub (not supplied)
L
Also connect networked computers.
7 LAN cable (not supplied)
L
To assure continued emission limit compliance,
only use a shielded LAN cable (category 5
straight cable).
only use a shielded LAN cable (category 5
straight cable).
8 Handset unit (optional) connection jack
L
You can connect the optional handset unit.
Remove the cover if attached.
Remove the cover if attached.
9 Automatic duplex unit (optional) connector
1
5
3
6
9
j
2
4
7
8
IMPORTANT NOTICE FOR THE USB
CONNECTION
CONNECTION
L
DO NOT CONNECT THE UNIT TO A
COMPUTER WITH THE USB CABLE UNTIL
PROMPTED BY THE MULTI-FUNCTION
STATION (page 12).
COMPUTER WITH THE USB CABLE UNTIL
PROMPTED BY THE MULTI-FUNCTION
STATION (page 12).
1
MC210-PNQW1312YA-QRG-en.book Page 10 Thursday, November 13, 2008 4:33 PM