Panasonic KXTG2361JXB Operating Guide

If “No link to base. Move closer to base, try again.” is displayed 
even when using the handset near the base unit, the handset may have lost 
communication with the base unit. You need to re-register the handset to the base 
unit.
• Make sure the base unit is not being used.
• Have both handsets and base unit nearby during registration. 
• Follow steps 1–3 listed below. You have about 1 minute to complete them.
• Confirm the extension number of the handset which has lost the 

communication by placing the handset on the base unit or charger. 
If you re-register the handset using the other handset’s extension number, the 
other handset will not function. 

• If the handset beeps 3 times and “Error!!” is displayed, an error occurred. Try 

again from step 1.

• You can stop registration by pressing [OFF] on the handset, and pressing 

[LOCATOR/INTERCOM] on the base unit.

Base unit: Press and hold [LOCATOR/

INTERCOM] until a beep sounds.

• The CHARGE indicator flashes.

Base unit: Press the extension number [1] 

(

)  or  [2] (

) of the handset 

which has lost the communication.

Handset: Press and hold [FLASH/CALL 

WAIT] until “Handset

 

Registering” is displayed.

• When registration is complete, a beep sounds 

from the handset and the display shows the 
number.

Handset

  Registering

Handset [1]

   Registered

Ex. Extension number 1

TG2361JX.book  56 ページ  ２００９年１２月１７日　木曜日　午前１１時５５分