Panasonic KXTG2361JXB Operating Guide

If the handset display shows error messages, see “If the Following Appears 
on Your Display...” (p. 72–73) for the Cause & Remedy.

“No link to base. Move 
closer to base, try 
again.” is displayed and an 
alarm tone sounds.

• You are too far from the base unit. Walk 

closer to the base unit.

• Confirm the base unit’s AC adaptor is 

plugged in.

• Raise the base unit antenna.
• If the above remedies do not solve the 

problem, the handset may have lost 
communication with the base unit. Register 
the handset again (p. 56).

Static, sound cuts in/out, fades. 
Interference from other 
electrical units.

• Move the handset and base unit away from 

other electrical appliances (p. 3).

• Walk closer to the base unit.
• Raise the base unit antenna.
• If the unit is connected to a telephone line 

with DSL service, you may hear noise from 
the receiver or speaker during 
conversations. We recommend connecting 
a noise filter (contact your DSL service 
provider) to the telephone line between the 
unit and the telephone line jack.

The handset and/or base unit 
does not ring.

• The ringer volume is turned off. Set to high, 

medium or, low (p. 17, 18).

The handset display is blank.

• If the only handset display is blank, fully 

charge the battery (p. 10).

You cannot program any 
function items.

• Programming is not possible while the 

handset and/or base unit is being used.

• Do not pause for over 60 seconds while 

programming.

• Walk closer to the base unit.
• While another user is listening to messages 

or the Answering System is handling a call, 
you cannot program. Try again later.

• When the Dial Lock is turned on (p. 54), you 

cannot store the phone number in the phone 
book.

While programming or 
searching, the handset starts 
to ring and the program/search 
stops.

• A call is coming in. To answer the call, press 

[C], [s] or [SP-PHONE]. Start again from 
the beginning after hanging up.

TG2361JX.book  74 ページ  ２００９年１２月１７日　木曜日　午前１１時５５分