Panasonic AG520E Operating Guide
36
On-Screen Displays (OSD)
Warning and Instruction Displays
These displays will alert you to a missed
operation or provide further instructions.
operation or provide further instructions.
OSD
NO CH FOUND PLEASE CHECK
ANTENNA CABLE CONNECTION THEN
PUSH CH UP KEY AGAIN
ANTENNA CABLE CONNECTION THEN
PUSH CH UP KEY AGAIN
PLEASE SET CLOCK BEFORE
PROGRAMMING
PROGRAMMING
CHECK CASSETTE RECORD TAB
TO CANCEL TIMER REC HOLD DOWN
STOP KEY FOR APPROX 3 SEC
STOP KEY FOR APPROX 3 SEC
NO CASSETTE
PLEASE INSERT A CASSETTE
PLEASE INSERT A CASSETTE
PLEASE PREPARE FOR TIMER REC
VIDEO HEADS MAY NEED CLEANING
PLEASE INSERT HEAD CLEANING
CASSETTE OR REFER TO MANUAL
END: PLAY KEY
PLEASE INSERT HEAD CLEANING
CASSETTE OR REFER TO MANUAL
END: PLAY KEY
VCR LOCK ACTIVATED
Caution
• If no active channels are found for CHANNEL
MEMORY...
• If you attempt to set or review a Timer Recording,
or set the On-Timer and the Clock is not set...
• If you press REC, and a cassette is inserted with
no record tab...
• If you press STOP during a Timer Recording...
• If you press PLAY, FF, REW, or REC without a
cassette inserted...
• If the unit is not in Stop mode or a cassette with
record tab is not inserted two minutes before a
Timer Recording is about to begin...
Timer Recording is about to begin...
• If head cleaning becomes necessary while
playing back a tape...
• If you press a function button other than STOP/
EJECT or POWER while the unit is in VCR Lock
mode...
mode...
Page
8, 10, 12
12, 13
4, 14
23
14
22, 23
4
30
VCR Status & Clock Display
Press DISPLAY
to display or remove the overlay.
to display or remove the overlay.
Whenever a blank section of a
tape comes up in Play mode, or
when the selected channel has no
broadcast signal with the Weak
Signal Display Feature set to
“OFF” (see page 30), the screen
will turn solid blue.
tape comes up in Play mode, or
when the selected channel has no
broadcast signal with the Weak
Signal Display Feature set to
“OFF” (see page 30), the screen
will turn solid blue.
Blue Screen Display
When a function button is pressed
(PLAY, FF, etc.) or you change
channels, the unit mode or channel
number will be displayed. (Some
station names may also appear if
Channel Caption is set. See pages
28 and 29.)
(PLAY, FF, etc.) or you change
channels, the unit mode or channel
number will be displayed. (Some
station names may also appear if
Channel Caption is set. See pages
28 and 29.)
0 8
ABC
Channel & Function Display
REC 1 2 : 0 0PM
0 : 25
0 : 25
ABC
-0 : 1 2 : 3 4
SP
12 / 2 4 / 2 0 0 1 MON
12 : 0 0PM - 1 : 0 0PM
CH 0 8 ABC
12 : 0 0PM - 1 : 0 0PM
CH 0 8 ABC
ABC MOV I E
Function Status
Current Time
Rec Time Remaining
(OTR mode only,
see page 14.)
(OTR mode only,
see page 14.)
Counter
Tape Speed
(See page 4.)
(See page 4.)
Channel Caption
(See pages 28, 29.)
(See pages 28, 29.)
Time Stamp Data (See page 31.)