Panasonic TH-65VX300ER Operating Guide
43
Setup menu
Power save
PC Power management
Standby save
No signal power off
No activity power off
Off
On
When this function is turned On, luminous level of the Plasma Display is suppressed, so power consumption is
reduced.
reduced.
Disable
Enable
Equipment power supply is turned Off when there is no signal.
When this is set to “Enable”, the power supply of the unit goes Off 10 minutes after the input signals stop.
When this is set to “Enable”, the power supply of the unit goes Off 10 minutes after the input signals stop.
Enable
Disable
When this function is set to “Enable”, the power is turned off (standby) automatically when there is no operation of
the Plasma Display for 4 hours.
Starting from 3 minutes before the turn off, the remaining time will be displayed.
No activity power off 3min
Press any key to abort.
When the power is turned off due to this function, a message “Last turn off due to ’No activity power off’.” is
displayed next time the power is turned on.
Note:
During the screensaver is running, this function is disabled.
Off
On
When this function is set to On, it operates under the following conditions to turn the power on or off automatically.
When no pictures (HD/VD sync signals) are detected for 30 or so seconds during PC signal input:
→ Power is turned off (standby); the power indicator lights up orange.
When pictures (HD/VD sync signals) are subsequently detected:
→ Power is turned on; the power indicator lights up green.
Notes:
• This function operates only during PC signal input.
• This function is effective when “Sync” is set to “Auto”, “Component / RGB-in select” is set to “RGB”.
When no pictures (HD/VD sync signals) are detected for 30 or so seconds during PC signal input:
→ Power is turned off (standby); the power indicator lights up orange.
When pictures (HD/VD sync signals) are subsequently detected:
→ Power is turned on; the power indicator lights up green.
Notes:
• This function operates only during PC signal input.
• This function is effective when “Sync” is set to “Auto”, “Component / RGB-in select” is set to “RGB”.
Off
On
When this function is turned On, power consumption of the microcomputer is reduced during power supply standby
(see page 15, 17, 19), so standby power of the set is reduced.
(see page 15, 17, 19), so standby power of the set is reduced.