Panasonic ICX Manual

Built-In ACD Supervisor Guide

Section 521

ICX-5.0-521 (ACD 4.0)

ICX (International) issued October 2000

11

The following describes the

 

operation in each of the processes.

This command resets the current setting of displayed program lines. Edit is 
repeated from the specified program line through to the currently registered 
final program line (excluding the END/DISC line).

The following screen display shows an example of selection and setting of the 
SEARCH command.

1. Press 

soft keys 1, 2, or 3 or 6, 7 or 8 for the command to be set, 

and press the HOLD key.
Example: Press soft key 3 to select SEARCH.

6

RET

Program Line 
Number Set-
ting 1 to 20 
(max. 20 
lines) 
(must be set)

Count Set-
ting 1 to 255 
(times) 
(must be set)

Return
• Repeats the program from the line number speci-

fied in parameter 1 up to this line for the count 
specified in parameter 2.

7

RAD

Port #

Recorded Announcement Device
• The caller hears MOH if the RAD port# is invalid 

or incorrect.

• The ICX Built-in ACD must use different RAD 

ports than Easy Run Courier ACD.

• RAD equipment will connect to AEC ports.
• No start or stop control method will be provided 

to control the RAD equipment.  RAD equipment 
must be capable of operating in the continuous 
play mode.

• Up to 8 RAD devices can be connected to AEC’s 

per system.

• This command must be followed by a SEARCH, 

FWD or FWDVM command.

• For programming (See Section 400 Programming 

Manual on page 1-168)

→