Panasonic S-ICX Manual
306
S-ICX (International) issued October 2000
S-ICX-50-700
Chapter 7. SLT Features
Section 700 - Operation
•
N/A
MCO Trunk Access
The System supports up to 5 MCO groups for each MCO tenant group. You can seize an idle trunk
from the MCO trunk group by entering the MCO access code.
from the MCO trunk group by entering the MCO access code.
Operation
To seize an idle trunk:
Hardware Requirements
•
N/A
Related Programming
•
FF1: MCO Access
•
FF5-2: MCO Trunk Group (Outbound)
•
FF7: ARS/TRS (Call Barring)
Considerations
•
The System supports up to 576 outside lines in a six-CCU configuration. These lines can be
divided into 99 different trunk groups.
divided into 99 different trunk groups.
•
Each trunk group can support up to 50 outside lines.
•
Each MCO Tenant Group can have up to 5 MCO trunk access codes. System defaults for MCO
trunk access codes are displayed in the following table.
trunk access codes are displayed in the following table.
•
MCO1 can have up to 5 trunk groups assigned by the Advanced Trunk Group feature.
•
MCO1 access code is used for Automatic Route Selection (ARS) access code.
Table 24. MCO Trunk Access Codes
Action
Result
1. Lift the handset.
Intercom dial tone
2. Enter the desired trunk access number (9 [UK/HK], 0 [Tai-
wan, Malaysia, Indonesia], or 81-84). (See Table 24 on page
306.)
306.)
Outside dial tone
3. Dial the phone number.
MCO Group
Trunk Access Code
MCO1
9
(UK/HK) or
0
(Taiwan,
Malaysia, Indonesia)
MCO2
81
MCO3
82
MCO4
83
MCO5
84