Cisco 2811 ROUTER 2FE 1NME 4HWIC 2PVDM 2AIM IP BASE WITH A/C POWER SUPPLY Specification Guide
7
Installing Network Modules in Cisco 2800 Series Routers
OL-5790-01
Installing Blank Panels over Empty Chassis Slots
Installing Blank Panels over Empty Chassis Slots
All empty chassis slots for network modules must be covered with blank panels. Blank panels are
required to ensure proper cooling airflow and to prevent electromagnetic interference.
required to ensure proper cooling airflow and to prevent electromagnetic interference.
shows a
typical blank panel.
Figure 9
Typical Blank Panel
Blank Panels for Network Module Slots
The network module hardware kit for Cisco 2800 series routers contains two blank panels. Each blank
panel covers one single-wide network module slot.
panel covers one single-wide network module slot.
Install blank panels over empty network module slots as follows:
•
Single-wide slot—Attach a blank panel.
•
Extended single-wide slot—Install an adapter/filler panel as described in the
section; then attach a blank panel.
Related Product Documentation
The following documentation is related to your product. This documentation was not shipped with your
product, but you can access it online at Cisco.com.
product, but you can access it online at Cisco.com.
121064