Cisco 2811 ROUTER 2FE 1NME 4HWIC 2PVDM 2AIM IP BASE WITH A/C POWER SUPPLY Specification Guide

Cisco IOS software of a specified release or later release is required to use an AIM.

To determine the version of Cisco IOS software that is running on your router, log in to the router and 
enter the show version command:

Router> show version

Cisco Internetwork Operating System Software 

2800 Software (C2800-ADVENTERPRISEK9-M), Version 12.3(8.2)T, INTERIM SOFTWARE

The two AIM connectors are located on the system board and are identified as AIM 0 and AIM 1. Refer 
to 

, 

 for the location of the AIM connectors.

To remove an AIM, perform the following procedure. To complete this procedure, you need a number 2 
Phillips screwdriver or flat-blade screwdriver.

Locate the AIM to be removed. See 

, 

, depending on your 

router model, for the location of the AIMs.

Remove the two screws from the AIM as shown in 

103526