Cisco 2811 ROUTER 2FE 1NME 4HWIC 2PVDM 2AIM IP BASE WITH A/C POWER SUPPLY Specification Guide

Check that the AIM is installed correctly on the system board. See 

.

If you are finished installing modules, install the cover on the router. See the 

Apply the AIM label to the outside of the chassis as described in the 

Cisco 2811, Cisco 2821, and Cisco 2851 routers have two AIM connectors—AIM slot 0 and AIM slot 1. 
You can install a virtual private network (VPN) encryption AIM or a voice-mail AIM in either slot, but 
not in both slots. You can install voice and data compression AIMs and ATM AIMs in both slots.

To install AIM modules in Cisco 2811, Cisco 2821, or Cisco 2851 routers, use accessory kit number 
69-0926-01.

To install an AIM in a Cisco 2811, Cisco 2821, or Cisco 2851 router, follow these steps.

If the mounting hardware is already in place on the system board, or if you are replacing an existing AIM, 
skip 

 through 

.

Locate the AIM connector. 

Remove the three screws from the system board near the AIM connector that you are going to use. 
(

 shows the screws to remove for AIM installation in AIM slot 1.)

58696